Load page
107
■ Loading programs
Here’s how to load one or more program files from a storage device into internal memory.
1. Access the Load page and move the cursor to the Disk field.
2. Turn the [JOG] dial to open the Disk List popup window.
3. Move the cursor to the storage device from which you want to load the data,
and press the [F6] key (SELECT).
The load-source storage device will be selected.
4. Move the cursor to the view block, and turn the [JOG] dial to select PROGRAM.
Only program files will be displayed in the file list block.
● To load a single program
5. Move the cursor to the file list block, and select the program file that you want
to load.
6. Press the [F6] key (DO IT).
The Load a program popup window will appear.
A Load field
Specify whether samples used by that program will also be loaded.
B Replace same sample in memory field
Specify what will be done if an identically-named sample already exists in internal mem-
ory.
C [F1] key (CANCEL)
Cancels the Load operation and closes the popup window.
D [F3] key (CLEAR)
Clears internal memory before loading the data.
E [F5] key (DO IT)
Loads the data.
7. Move the cursor to the Load field, and select one of the following ways in which
the program will be loaded.
PROGRAM ONLY .......... Only the program will be loaded.
WITH SAMPLES ............ The program and the necessary samples will be loaded.
8. If you selected WITH SAMPLES in step 7, move the cursor to the Replace same
sample in memory field, and specify what will be done if an identically-named
sample already exists in internal memory.
YES........................The identically-named sample will be overwritten by the loaded
sample.
NO..........................Identically-named sample data will not be loaded.
Note: Be aware that if you select PROGRAM ONLY, the program cannot be played correctly if the
memory of the MPC4000 does not contains the necessary samples.
3 4 5
1
2
To Next Page
Loading...
Need help?
General
