Akai MPC 4000 User Manual

Memory page
117
Memory page
Viewing the amount of free memory
Here you can view the amount of free space in the MPC4000’s memory, check the mem-
ory, or defragment the memory.
To access this page ....... [GLOBAL] key → [F2] key (MEMORY)
A Memory block
Functions
• [F1] key (GLOBAL)
Displays the Global page.
• [F3] key (CONFIG)
Displays the Configuration page.
• [F4] key (FOOT SW)
Displays the Foot Switch page.
• [F5] key (TEST)
Tests the installed memory.
• [F6] key (DEFRAG)
Rearranges the various types of data in internal memory so that the free memory space is
contiguous.
Memory block
This area shows the amount of free memory within the MPC4000.
A Wave memory field
Indicates the total amount of memory installed in the MPC4000.
B Wave bar
The length of this bar indicates the amount of free sample memory. The percentage of
free memory is shown at the right of this bar.
C Sequencer bar
The length of this bar indicates the amount of free sequencer memory. The percentage of
free memory is shown at the right of this bar.
1
1
2
3
4
5
6
7

Akai MPC 4000 Specifications

General

Polyphony	64 voices
RAM	272 MB (expandable to 512 MB)
Pads	16 velocity and pressure-sensitive pads
MIDI	2 MIDI inputs, 4 MIDI outputs
Sampling Frequency	44.1 kHz
Display	240x64 backlit LCD
Effects	4 internal effects processors
Storage	Internal Hard Drive
Sequencer	300, 000 notes capacity
Filter	Multi-mode filter (Low Pass, High Pass, Band Pass, Band Boost, Band Reject)