Main mode
8
Depending on the value you select, one of the following fields will appear at the right of
the PART field.
If you select PART
If you select OUT-A–D
If you select INT-A/B
E Out2 field
Selects the second output destination of the track. You can choose from the same output
destinations as the Out1 field, or OFF.
F Pgm change field
Specifies the program change number that will be sent to the output destination of the
track. The program change number you specify here will be transmitted when you press
the [PLAY START] key, or when the sequence is switched while using the Next Sequence
function or Song function. If this setting is OFF, a program change will not be transmitted.
If you move the cursor to this field and press the [WINDOW] key, the Program Change
popup window will appear.
G Trans. field
Transposes the playback of the selected track upward or downward in a range of –12–+12
semitones. (The note events recorded in the track will not be affected.) This field will be
displayed only if the track type is INST.
If you move the cursor to this field and press the [WINDOW] key, the Transpose Perma-
nent popup window will appear, allowing you to rewrite the pitches of the note events
recorded in the track.
H Duration field
This lets you apply a relative adjustment during playback to the duration (note length) of
the note events recorded in the selected track. (This does not affect the note events recorded
in the track.) The range is 1–200%. With a setting of 100% the durations will be unchanged.
If you move the cursor to this field and press the [WINDOW] key, the Edit Duration
popup window will appear, allowing you to rewrite the durations of the note events
recorded in the track.
OUT1 field display Field Content
PART Part field (left of field) Selects the destination part number.
Program field (right of field)
Displays the program name assigned to
the part.
MIDI A–D Ch field Selects MIDI channel 1–16 or ANY as the
output destination.
Device field Displays the device name for the MIDI
channel selected in the Ch field.
INT-A/B Ch field Selects MIDI channel 1–16 or ANY as the
output destination.
Hint: If you select ANY for the Ch field, the MIDI channel that was input to the track will also be used
as the output channel.
If you press the [WINDOW] key at the Device field, the Device List popup window will appear, allowing
you to edit the device name.
To Next Page
Loading...
Need help?
General
