Program mode
204
■ Making program modulation settings
Here’s how to specify the modulation source, modulation destination, and modulation
depth for each of the 64 modulation routings of a program.
1. In the List page, move the cursor to any one of the Lvl/Pan/Out/FX/Send fields,
and press the [WINDOW] key.
The Program Modulation popup window will appear.
A Mod field
Indicates the modulation number (1–64).
B Source field
Selects the modulation source (modulation wheel, filter envelope, velocity, LFO1, LFO2,
etc.).
C Destination field
Selects the modulation destination parameter (amplitude, pan, pitch, etc.)
D Note/Kg field
Selects the key group or note number whose modulation depth you want to set. By select-
ing ALL you can set the depth for all key groups or note numbers at once.
E Depth field
Specifies the modulation depth.
F [F1] key (CLOSE)
Updates the settings and closes the popup window.
2. Move the cursor to the Mod field, and turn the [JOG] dial to select a
modulation number.
3. Move the cursor to the Source field, and turn the [JOG] dial to select one of the
following modulation sources.
MODWHEEL, BEND UP, BEND DOWN, AFT TOUCH, VELOCITY, OFF VELO,
KEYBORD, LFO1, LFO2, AMP ENV, FILT ENV, AUX ENV, CONTROLLER: (lets
Hint: The Program Modulation popup window can also be accessed from the key group mix Pitch,
Edit 1, Edit 2, or Zone pages. For the fields that will appear when you open the popup window, refer
to the explanations in each page.
6
1
2 3 4 5
To Next Page
Loading...
Need help?
General
