WARNING: WHEN USING ELECTRIC PRODUCTS, BASIC PRECAUTIONS SHOULD ALWAYS
BE FOLLOWED, INCLUDING THE FOLLOWING:
WARNING
The MPC4000 is designed to be used in a standard household environment.
Power requirements for electrical equipment vary from area to area. Please ensure that your MPC4000
meets the power requirements in your area. If in doubt, consult a qualified electrician or AKAI profes-
sional dealer.
120 VAC @ 60 Hz for USA and Canada
220~240 VAC @ 50 Hz for Europe
240 VAC @ 50 Hz for Australia
PROTECTING YOURSELF AND THE MPC4000
• Never touch the AC plug with wet hands.
• Always disconnect the MPC4000 from the power supply by pulling on the plug, not the cord.
• Allow only an AKAI professional dealer or qualified professional engineer to repair or reas-
semble the MPC4000. Apart from voiding the warranty, unauthorized engineers might touch
live internal parts and receive a serious electrical shock. There are no user serviceable parts
inside.
• Do not put, or allow anyone to put any object, especially metal objects, into the MPC4000.
• Use only a household AC power supply. Never use a DC power supply.
• If water or any other liquid is spilled into or onto the MPC4000, disconnect the power, and call
your dealer.
• Make sure that the unit is well-ventilated, and away from direct sunlight.
• To avoid damage to internal circuitry, as well as the external finish, keep the MPC4000 away
from sources of direct heat (stoves, radiators, etc.).
• Avoid using aerosol insecticides, etc. near the MPC4000. They may damage the surface, and
may ignite.
• Do not use denatured alcohol, thinner or similar chemicals to clean the MPC4000. They will
damage the finish.
• Modification of this equipment is dangerous, and can result in the functions of the MPC4000
being impaired. Never attempt to modify the equipment in any way.
• Make sure that the MPC4000 is always well-supported when in use (either in a specially-
designed equipment rack, or on a firm level surface).
• In order to assure optimum performance of your MPC4000, select the setup location carefully,
and make sure the equipment is used properly. Avoid setting up the MPC4000 in the following
locations:
1. In a humid or dusty environment
2. In a room with poor ventilation
3. On a surface which is not horizontal
4. Inside a vehicle such as a car, where it will be subject to vibration
5. In an extremely hot or cold environment
To Next Page
Loading...
Need help?
General
