show lacp_port
Purpose Used to display current LACP port mode settings.
Syntax
show lacp_port {<por
tlist>}
Description This command will display the LACP mode settings as they are currently configured.
Parameters <portlist> – Specifies a range of ports that will be viewed.The port list is specified by listing the lowest switch
number and the beginning port number on that switch, separated by a colon.Then the highest switch number,
and the highest port number of the range (also separated by a colon) are specified.The beginning and end of
the port list range are separated by a dash. For example, 1:3 specifies switch number 1, port 3. 2:4 specifies
switch number 2, port 4. 1:3-2:4 specifies all of the ports between switch 1, port 3 and switch 2, port 4 – in
numerical order.
Restrictions Only administrator-level users can issue this command.
Example usage:
To display LACP port mode settings:
AT-9724TS:4# show lacp_port 1:1-1:8
Command: show lacp_port 1:1-1:8
P o r t A c t i v i t y
- - - - - - - - - - - - - -
1 : 1 A c t i v e
1 : 2 A c t i v e
1 : 3 A c t i v e
1 : 4 A c t i v e
1 : 5 A c t i v e
1 : 6 A c t i v e
1 : 7 A c t i v e
1 : 8 A c t i v e
A T - 9 7 2 4 T S : 4 #
115
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual
To Next Page
Loading...
Need help?
General
Weight and Dimensions
