Allied Telesis AT-9724TS Reference Manual

show ipif
Purpose Used to display the configuration of an IP interface on the Switch.
Syntax show ipif <ipif_name 12>
Description This command will display the configuration of an IP interface on the Switch.
Parameters <ipif_name 12> – The name created for the IP interface to be viewed.
Restrictions None.
Example usage:
To display the IP interface settings:
AT-9724TS:4# show ipif System
Command: show ipif System
IP Interface Settings
Interface Name : System
S e c o n d a r y : FALSE
IP Address : 10.48.74.122 ( M A N U A L )
Subnet Mask : 255.0.0.0
VLAN Name : default
Admin. State : Disabled
Link Status : Link UP
Member Ports : 1:1-1:24
A T - 9 7 2 4 T S : 4 #
Note: In the IP Interface Settings table shown above, the Secondary field will have two displays. FALSE denotes that the IP interface is a primary IP
interface whileTRUE denotes a secondary IP interface.
120
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual

Allied Telesis AT-9724TS Specifications

General

MAC address table	16000 entries
Packet buffer memory	2 MB
Maximum data transfer rate	88 Gbit/s
Full duplex	Yes
Dimensions (WxDxH)	440 x 210 x 44 mm
Power requirements	100-240V AC/50-60Hz
Management platform	SNMP, RMON
Networking features	IEEE 802.3 10T Ethernet, IEEE 802.3u 100TX Ethernet, IEEE 802.3ab 1000T Ethernet, IEEE 802.3z 1000X Ethernet
Connectivity technology	Wired
DHCP features	DHCP client
Security algorithms	SSH
Switch type	Managed
Switch layer	L3+
SFP/SFP+ slots quantity	4
Basic switching RJ-45 Ethernet ports quantity	24
Memory type	SDRAM / Flash
Flash memory	16 MB
Internal memory	256 MB
Power consumption (typical)	90 W
Certification	UL 1950 FCC Class A CSA 22.2 No. 950 EN55022 Class A EN 60950 (TUV) EN50082-1 CE
Storage temperature (T-T)	-25 - 55 °C
Operating temperature (T-T)	0 - 40 °C

Weight and Dimensions

Weight	3200 g