Allied Telesis AT-9724TS Reference Manual

create ipif
Purpose Used to create an IP interface on the Switch.
Syntax create ipif <ipif_name 12> <network_address> <vlan_name 32> {secondary | {state
[enable | disable]}
Description This command will create an IP interface.
Parameters <ipif_name 12> – The name for the IP interface to be created.The user may enter an alphanumeric string of up
to 12 characters to define the IP interface.
<network_address> – IP address and netmask of the IP interface to be created.The address and mask
information can be specified using the traditional format (for example, 10.1.2.3/255.0.0.0 or in CIDR format,
10.1.2.3/8).
<vlan_name 32> – The name of the VLAN that will be associated with the above IP interface.
secondary – Enter this parameter if this configured IP interface is to be a secondary IP interface of the VLAN
previously specified. secondary interfaces can only be configured if a primary interface is first configured.
state [enable | disable] – Allows you to enable or disable the IP interface.
Restrictions Only administrator-level users can issue this command.
Example usage:
To create the primary IP interface, p1 on VLAN Trinity:
AT-9724TS:4# create ipif p1 ipaddress 10.1.1.1 Trinity
state enable
Command: create ipif p1 ipaddress 10.1.1.1 Trinity state
e n a b l e
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
To create the secondary IP interface, s1 on VLAN Trinity:
AT-9724TS:4# create ipif p1 ipaddress 12.1.1.1 Trinity
secondary state enable
Command: create ipif p1 ipaddress 12.1.1.1 Trinity
secondary state enable
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
117
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual

Allied Telesis AT-9724TS Specifications

General

MAC address table	16000 entries
Packet buffer memory	2 MB
Maximum data transfer rate	88 Gbit/s
Full duplex	Yes
Dimensions (WxDxH)	440 x 210 x 44 mm
Power requirements	100-240V AC/50-60Hz
Management platform	SNMP, RMON
Networking features	IEEE 802.3 10T Ethernet, IEEE 802.3u 100TX Ethernet, IEEE 802.3ab 1000T Ethernet, IEEE 802.3z 1000X Ethernet
Connectivity technology	Wired
DHCP features	DHCP client
Security algorithms	SSH
Switch type	Managed
Switch layer	L3+
SFP/SFP+ slots quantity	4
Basic switching RJ-45 Ethernet ports quantity	24
Memory type	SDRAM / Flash
Flash memory	16 MB
Internal memory	256 MB
Power consumption (typical)	90 W
Certification	UL 1950 FCC Class A CSA 22.2 No. 950 EN55022 Class A EN 60950 (TUV) EN50082-1 CE
Storage temperature (T-T)	-25 - 55 °C
Operating temperature (T-T)	0 - 40 °C

Weight and Dimensions

Weight	3200 g