Allied Telesis AT-9724TS Reference Manual

Chapter 20 - MAC Notification Commands
The MAC notification commands in the Command Line Interface (CLI) are listed, in the following table, along with their appropriate parameters.
Command Parameters
enable mac_notification
disable mac_notification
config mac_notification {interval <int 1-2147483647> | historysize <int 1-500>}
[<portlist> | all] [enable | disable]
show mac_notification
show mac_notification ports <portlist>
Each command is listed, in detail, in the following sections.
enable mac_notification
Purpose Used to enable global MAC address table notification on the Switch.
Syntax enable mac_notification
Description This command is used to enable MAC Address Notification without changing configuration.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example usage:
To enable MAC notification without changing basic configuration:
AT-9724TS:4# enable mac_notification
Command: enable mac_notification
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
disable mac_notification
Purpose Used to disable global MAC address table notification on the Switch.
Syntax disable mac_notification
Description This command is used to disable MAC Address Notification without changing configuration.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example usage:
To disable MAC notification without changing basic configuration:
AT-9724TS:4# disable mac_notification
Command: disable mac_notification
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
131
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual

Allied Telesis AT-9724TS Specifications

General

MAC address table	16000 entries
Packet buffer memory	2 MB
Maximum data transfer rate	88 Gbit/s
Full duplex	Yes
Dimensions (WxDxH)	440 x 210 x 44 mm
Power requirements	100-240V AC/50-60Hz
Management platform	SNMP, RMON
Networking features	IEEE 802.3 10T Ethernet, IEEE 802.3u 100TX Ethernet, IEEE 802.3ab 1000T Ethernet, IEEE 802.3z 1000X Ethernet
Connectivity technology	Wired
DHCP features	DHCP client
Security algorithms	SSH
Switch type	Managed
Switch layer	L3+
SFP/SFP+ slots quantity	4
Basic switching RJ-45 Ethernet ports quantity	24
Memory type	SDRAM / Flash
Flash memory	16 MB
Internal memory	256 MB
Power consumption (typical)	90 W
Certification	UL 1950 FCC Class A CSA 22.2 No. 950 EN55022 Class A EN 60950 (TUV) EN50082-1 CE
Storage temperature (T-T)	-25 - 55 °C
Operating temperature (T-T)	0 - 40 °C

Weight and Dimensions

Weight	3200 g