EasyManuals Logo

Allied Telesis AT-9724TS Reference Manual

Allied Telesis AT-9724TS
282 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #53 background imageLoading...
Page #53 background image
config firmware
Purpose To configure firmware currently in the Switch’s NV-RAM.
Syntax config firmware image_id <int 1-2> {delete | boot_up]
Description This command allows the user to configure the dual image firmware on the Switch.This Switch allows the user
to hold two firmware versions in its memory, labeled as image_id 1 and 2. Using this command, the user may
delete a firmware or set it as the boot up firmware for the Switch. If the boot up firmware is not specified by
the user, image_id 1 will be the default boot up firmware.
Parameters <int 1-2> – Select the ID number of the firmware in the Switch’s memory to be configured.
delete – Selecting this parameter, along with the image_id will delete this firmware from the Switch’s memory.
boot_up – Selecting this parameter, along with the image_id will set this firmware as the default boot up
runtime image firmware upon the next reboot of the Switch.
Restrictions Only administrator-level users can issue this command.
Example usage:
To delete a firmware from the Switch’s memory:
AT-9724TS:4# config firmware image_id 2 delete
Command: config firmware image_id 2 delete
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
Example usage:
To configure a firmware as the boot up runtime image firmware:
AT-9724TS:4# config firmware image_id 2 boot_up
Command: config firmware image_id 2 boot_up
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
52
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual

Table of Contents

Other manuals for Allied Telesis AT-9724TS

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Allied Telesis AT-9724TS and is the answer not in the manual?

Allied Telesis AT-9724TS Specifications

General IconGeneral
MAC address table16000 entries
Packet buffer memory2 MB
Maximum data transfer rate88 Gbit/s
Full duplexYes
Dimensions (WxDxH)440 x 210 x 44 mm
Power requirements100-240V AC/50-60Hz
Management platformSNMP, RMON
Networking featuresIEEE 802.3 10T Ethernet, IEEE 802.3u 100TX Ethernet, IEEE 802.3ab 1000T Ethernet, IEEE 802.3z 1000X Ethernet
Connectivity technologyWired
DHCP featuresDHCP client
Security algorithmsSSH
Switch typeManaged
Switch layerL3+
SFP/SFP+ slots quantity4
Basic switching RJ-45 Ethernet ports quantity24
Memory typeSDRAM / Flash
Flash memory16 MB
Internal memory256 MB
Power consumption (typical)90 W
CertificationUL 1950 FCC Class A CSA 22.2 No. 950 EN55022 Class A EN 60950 (TUV) EN50082-1 CE
Storage temperature (T-T)-25 - 55 °C
Operating temperature (T-T)0 - 40 °C
Weight and Dimensions IconWeight and Dimensions
Weight3200 g

Related product manuals