show traffic control
Purpose Used to display current traffic control settings.
Syntax show traffic control {group_list <storm_grouplist>}
Description This command displays the current storm traffic control configuration on the Switch.
Parameters group_list <storm_grouplist> – Used to specify a broadcast storm control group.This is specified by listing the
lowest switch number and the beginning port number on that switch, separated by a colon.Then the highest
switch number, and the highest port number of the range (also separated by a colon) are specified.The
beginning and end of the port list range are separated by a dash. For example, 1:3 specifies switch number 1,
port 3. 2:4 specifies switch number 2, port 4. 1:3-2:4 specifies all of the ports between switch 1, port 3 and
switch 2, port 4 – in numerical order.
Restrictions None.
Example usage:
To display traffic control setting:
AT-9724TS:4# show traffic control group_list 1:1-1:5
Command: show traffic control group_list 1:1-1:5
Traffic Control
M o d u l e Group (ports) T h r e s h o l d B r o a d c a s t M u l t i c a s t D e s t i n a t i o n
S t o r m S t o r m Lookup Fail
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
1 1 1 2 8 D i s a b l e d D i s a b l e d D i s a b l e d
1 2 1 2 8 D i s a b l e d D i s a b l e d D i s a b l e d
1 3 1 2 8 D i s a b l e d D i s a b l e d D i s a b l e d
1 4 1 2 8 D i s a b l e d D i s a b l e d D i s a b l e d
1 5 1 2 8 D i s a b l e d D i s a b l e d D i s a b l e d
Total Entries: 5
A T - 9 7 2 4 T S : 4 #
89
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual
To Next Page
Loading...
Need help?
General
Weight and Dimensions
