Allied Telesis AT-9724TS Reference Manual

enable admin
Purpose Used to promote user level privileges to administrator level privileges.
Syntax enable admin
Description This command is for users who have logged on to the Switch on the normal user level, to become promoted
to the administrator level.After logging on to the Switch users, will have only user level privileges.To gain access
to administrator level privileges,the user will enter this command and will have to enter an authentication
password.Possible authentication methods for this function include TACACS/XTACACS/TACACS+, RADIUS,
user defined server groups, local enable (local account on the Switch), or no authentication (none). Because
XTACACS and TACACS do not support the enable function, the user must create a special account on the
server host which has the username “enable”, and a password configured by the administrator that will support
the “enable” function.This function becomes inoperable when the authentication policy is disabled.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example usage:
To enable administrator privileges on the Switch:
AT-9724TS:4# enable admin
P a s s w o r d : * * * * * *
A T - 9 7 2 4 T S : 4 #
config admin local_enable
Purpose Used to configure the local enable password for administrator level privileges.
Syntax config admin local_enable
Description This command will configure the locally enabled password for the enable admin command.When a user
chooses the “local_enable” method to promote user level privileges to administrator privileges, he or she will
be prompted to enter the password configured here, that is set locally on the Switch.
Parameters <password 15> – After entering this command, the user will be prompted to enter the old password, then a
new password in an alphanumeric string of no more than 15 characters, and finally prompted to enter the new
password again to confirm.See the example below.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure the password for the “local_enable” authentication method:
AT-9724TS:4# config admin local_enable
Command: config admin local_enable
Enter the old password: ******
Enter the case-sensitive new password:******
Enter the new password again for confirmation:******
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
153
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual

Allied Telesis AT-9724TS Specifications

General

MAC address table	16000 entries
Packet buffer memory	2 MB
Maximum data transfer rate	88 Gbit/s
Full duplex	Yes
Dimensions (WxDxH)	440 x 210 x 44 mm
Power requirements	100-240V AC/50-60Hz
Management platform	SNMP, RMON
Networking features	IEEE 802.3 10T Ethernet, IEEE 802.3u 100TX Ethernet, IEEE 802.3ab 1000T Ethernet, IEEE 802.3z 1000X Ethernet
Connectivity technology	Wired
DHCP features	DHCP client
Security algorithms	SSH
Switch type	Managed
Switch layer	L3+
SFP/SFP+ slots quantity	4
Basic switching RJ-45 Ethernet ports quantity	24
Memory type	SDRAM / Flash
Flash memory	16 MB
Internal memory	256 MB
Power consumption (typical)	90 W
Certification	UL 1950 FCC Class A CSA 22.2 No. 950 EN55022 Class A EN 60950 (TUV) EN50082-1 CE
Storage temperature (T-T)	-25 - 55 °C
Operating temperature (T-T)	0 - 40 °C

Weight and Dimensions

Weight	3200 g