show authen application
Purpose Used to display authentication methods for the various applications on the Switch.
Syntax show authen application
Description This command will display all of the authentication method lists (login, enable administrator privileges) for
switch configuration applications (console, telnet, SSH, web) currently configured on the Switch.
Parameters None.
Restrictions None.
Example usage:
To display the login and enable method list for all applications on the Switch:
AT-9724TS:4# show authen application
Command: show authen application
A p p l i c a t i o n Login Method List Enable Method List
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
C o n s o l e d e f a u l t d e f a u l t
T e l n e t T r i n i t y d e f a u l t
S S H d e f a u l t d e f a u l t
H T T P d e f a u l t d e f a u l t
A T - 9 7 2 4 T S : 4 #
create authen server_host
Purpose Used to create an authentication server host.
Syntax create authen server_host <ipaddr> protocol [tacacs | xtacacs | tacacs+ | radius] {port
<int 1-65535> | key [<key_string 254> | none] | timeout <int 1-255> | retransmit < 1-
255>}
Description This command will create an authentication server host for the TACACS/XTACACS/TACACS+ and RADIUS
security protocols on the Switch.When a user attempts to access the Switch with authentication protocol
enabled, the Switch will send authentication packets to a remote TACACS/XTACACS/TACACS+ or RADIUS
server host on a remote host.The TACACS/XTACACS/TACACS+ or RADIUS server host will then verify or
deny the request and return the appropriate message to the Switch. More than one authentication protocol can
be run on the same physical server host but, remember that TACACS/XTACACS/TACACS+ and RADIUS are
separate entities and are not compatible with each other.The maximum supported number of server hosts is
16.
Parameters server_host <ipaddr> - The IP address of the remote server host the user wishes to add the user wishes to add.
protocol – The protocol used by the server host.The user may choose one of the following:
tacacs – Enter this parameter if the server host utilizes the TACACS protocol.
xtacacs – Enter this parameter if the server host utilizes the XTACACS protocol.
tacacs+ – Enter this parameter if the server host utilizes the TACACS+ protocol.
radius – Enter this parameter if the server host utilizes the RADIUS protocol.
port <int 1-65535> - Enter a number between 1 and 65535 to define the virtual port number of the
authentication protocol on a server host.The default port number is 49 for TACACS/XTACACS/TACACS+
servers but the user may set a unique port number for higher security.The default port number of the
authentication protocol on the RADIUS server is 1812
key <key_string 254> - Authentication key to be shared with a configured TACACS+ server only. Specify an
alphanumeric string up to 254 characters.
timeout <int 1-255> - Enter the time in seconds the Switch will wait for the server host to reply to an
authentication request.The default value is 5 seconds.
retransmit <int 1-255> - Enter the value in the retransmit field to change how many times the device will resend
an authentication request when the TACACS/XTACACS/TACACS+ or RADIUS server does not respond.
Restrictions Only administrator-level users can issue this command.
146
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual
To Next Page
Loading...
Need help?
General
Weight and Dimensions
