Allied Telesis AT-9724TS Reference Manual

disable syslog
Purpose Used to disable the system log function on the Switch.
Syntax disable syslog
Description The disable syslog command disables the system log function on the Switch.After disabling, Syslog entries
will no longer be sent to a remote host.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example usage:
To disable the syslog function on the Switch:
AT-9724TS:4# disable syslog
Command: disable syslog
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
show syslog
Purpose Used to display the syslog protocol status as enabled or disabled.
Syntax show syslog
Description The show syslog command displays the syslog status as enabled or disabled.
Parameters None.
Restrictions None.
Example usage:
To display the current status of the syslog function:
AT-9724TS:4# show syslog
Command: show syslog
Syslog Global State:
E n a b l e d .
A T - 9 7 2 4 T S : 4 #
create syslog host
Purpose Used to create a new syslog host.
Syntax show create syslog host [<index 1-4>] {severity [informational | warning | all] facility
[local0 | local1 | local2 | local3 | local4 | local5 | local6 | local7] | udp_port<int> | ipaddress
<ipaddr> | state [enable | disable]
Description The create syslog host command is used to create a new syslog host.
Parameters <index 1-4> – Specifies that the command will be applied to an index of hosts.There are four available indexes,
numbered 1 through 4.
severity – Severity level indicator.These are described in the following:
Bold font indicates that the corresponding severity level is currently supported on the Switch.
Numerical Code Severity
0 Emergency: system is unusable
1 Alert: action must be taken immediately
2 Critical: critical conditions
3 Error: error conditions
61
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual

Allied Telesis AT-9724TS Specifications

General

MAC address table	16000 entries
Packet buffer memory	2 MB
Maximum data transfer rate	88 Gbit/s
Full duplex	Yes
Dimensions (WxDxH)	440 x 210 x 44 mm
Power requirements	100-240V AC/50-60Hz
Management platform	SNMP, RMON
Networking features	IEEE 802.3 10T Ethernet, IEEE 802.3u 100TX Ethernet, IEEE 802.3ab 1000T Ethernet, IEEE 802.3z 1000X Ethernet
Connectivity technology	Wired
DHCP features	DHCP client
Security algorithms	SSH
Switch type	Managed
Switch layer	L3+
SFP/SFP+ slots quantity	4
Basic switching RJ-45 Ethernet ports quantity	24
Memory type	SDRAM / Flash
Flash memory	16 MB
Internal memory	256 MB
Power consumption (typical)	90 W
Certification	UL 1950 FCC Class A CSA 22.2 No. 950 EN55022 Class A EN 60950 (TUV) EN50082-1 CE
Storage temperature (T-T)	-25 - 55 °C
Operating temperature (T-T)	0 - 40 °C

Weight and Dimensions

Weight	3200 g