enable rip
Purpose Used to enable RIP.
Syntax enable rip
Description This command is used to enable RIP on the Switch.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example usage:
To enable RIP:
AT-9724TS:4# config rip ipif System rx_mode v1_only
Command: config rip ipif System rx_mode v1_only
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
disable rip
Purpose Used to disable RIP.
Syntax disable rip
Description This command is used to disable RIP on the Switch.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example usage:
To disable RIP:
AT-9724TS:4# disable rip
Command: disable rip
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
237
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual