show error ports
Purpose Used to display the error statistics for a range of ports.
Syntax show error ports <portlist>
Description This command will display all of the packet error statistics collected and logged by the Switch for a given port
list.
Parameters <portlist> – Specifies a range of ports to be displayed.The port list is specified by listing the lowest switch
number and the beginning port number on that switch, separated by a colon.Then the highest switch number,
and the highest port number of the range (also separated by a colon) are specified.The beginning and end of
the port list range are separated by a dash. For example, 1:3 specifies switch number 1, port 3. 2:4 specifies
switch number 2, port 4. 1:3-2:4 specifies all of the ports between switch 1, port 3 and switch 2, port 4 – in
numerical order.
Restrictions None.
Example usage:
To display the errors of the port 3 of module 1:
AT-9724TS:4# show errors ports 1:3
Command: traceroute 10.48.74.121 probe 3
R X F r a m e s T X F r a m e s
- - - - - - - - - - - - - - - - - -
CRC Error 1 9 Excessive Deferral 0
U n d e r s i z e 0 CRC Error 0
O v e r s i z e 0 Late Collision 0
F r a g m e n t 0 Excessive Collision 0
J a b b e r 1 1 Single Collision 0
Drop Pkts 2 0 8 3 7 C o l l i s i o n 0
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
57
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual