Allied Telesis AT-9724TS Reference Manual

enable snmp traps
Purpose Used to enable SNMP trap support.
Syntax enable snmp traps
Description The enable snmp traps command is used to enable SNMP trap support on the Switch.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example usage:
To enable SNMP trap support on the Switch:
AT-9724TS:4# enable snmp traps
Command: enable snmp traps
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
enable snmp authenticate_traps
Purpose Used to enable SNMP authentication trap support.
Syntax enable snmp authenticate_traps
Description This command is used to enable SNMP authentication trap support on the Switch.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example usage:
To turn on SNMP authentication trap support:
AT-9724TS:4# enable snmp authenticate_traps
Command: enable snmp authenticate_traps
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
show snmp traps
Purpose Used to show SNMP trap support on the Switch.
Syntax show snmp traps
Description This command is used to view the SNMP trap support status currently configured on the Switch.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example usage:
To view the current SNMP trap support:
AT-9724TS:4# show snmp traps
Command: show snmp traps
S N M P T r a p s : Enabled
Authenticate Traps : Enabled
A T - 9 7 2 4 T S : 4 #
46
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual

Allied Telesis AT-9724TS Specifications

General

MAC address table	16000 entries
Packet buffer memory	2 MB
Maximum data transfer rate	88 Gbit/s
Full duplex	Yes
Dimensions (WxDxH)	440 x 210 x 44 mm
Power requirements	100-240V AC/50-60Hz
Management platform	SNMP, RMON
Networking features	IEEE 802.3 10T Ethernet, IEEE 802.3u 100TX Ethernet, IEEE 802.3ab 1000T Ethernet, IEEE 802.3z 1000X Ethernet
Connectivity technology	Wired
DHCP features	DHCP client
Security algorithms	SSH
Switch type	Managed
Switch layer	L3+
SFP/SFP+ slots quantity	4
Basic switching RJ-45 Ethernet ports quantity	24
Memory type	SDRAM / Flash
Flash memory	16 MB
Internal memory	256 MB
Power consumption (typical)	90 W
Certification	UL 1950 FCC Class A CSA 22.2 No. 950 EN55022 Class A EN 60950 (TUV) EN50082-1 CE
Storage temperature (T-T)	-25 - 55 °C
Operating temperature (T-T)	0 - 40 °C

Weight and Dimensions

Weight	3200 g