enable telnet
Purpose Used to enable communication with and management of the Switch using the Telnet protocol.
Syntax enable telnet <tcp_port_number 1-65535>
Description This command is used to enable the Telnet protocol on the Switch.The user can specify the TCP or UDP port
number the Switch will use to listen for Telnet requests.
Parameters <tcp_port_number 1-65535> – The TCP port number.TCP ports are numbered between 1 and 65535.The
“well-known” TCP port for the Telnet protocol is 23.
Restrictions Only administrator-level users can issue this command.
Example usage:
To enable Telnet and configure port number:
AT-9724TS:4# enable telnet 23
Command:enable telnet 23
S u c c e s s
A T - 9 7 2 4 T S : 4 #
disable telnet
Purpose Used to disable the Telnet protocol on the Switch.
Syntax enable telnet
Description This command is used to disable the Telnet protocol on the Switch.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example usage:
To disable Telnet protocol on the Switch:
AT-9724TS:4# disable telnet
Command:disable telnet
S u c c e s s
A T - 9 7 2 4 T S : 4 #
23
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual