Allied Telesis AT-9724TS Reference Manual

79
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual
Chapter 11 - Forwarding Database Commands
The forwarding database commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following table.
Command Parameters
create fdb <vlan_name 32> <macaddr> port <port>
create multicast_fdb <vlan_name 32> <macaddr>
config multicast_fdb <vlan_name 32> <macaddr> [add | delete] <portlist>
config fdb aging_time <sec 10-1000000>
delete fdb <vlan_name 32> <macaddr>
clear fdb [vlan <vlan_name 32> | port <port>| all]
show multicast_fdb {vlan <vlan_name 32> | mac_address <macaddr>}
show fdb {port <port> | vlan <vlan_name 32> | mac_address <macaddr> | static | aging_time}
show ipfdb {<ipaddr>}
config fdb destination_hit ports [<portlist> | all ] {enable | disable]
show fdb destination_hit ports {<portlist>}
Each command is listed, in detail, in the following sections.
create fdb
Purpose Used to create a static entry to the unicast MAC address forwarding table (database).
Syntax create fdb <vlan_name 32> <macaddr> [port <port>]
Description This command will make an entry into the Switch’s unicast MAC address forwarding database.
Parameters <vlan_name 32> – The name of the VLAN on which the MAC address resides.
<macaddr> – The MAC address that will be added to the forwarding table.
port <port> – The port number corresponding to the MAC destination address.The Switch will always forward
traffic to the specified device through this port.The port is specified by listing the switch number and the port
number on that switch, separated by a colon. For example, 1:3 specifies switch number 1, port 3. 2:4 specifies
switch number 2, port 4.
Restrictions Only administrator-level users can issue this command.
Example usage:
To create a unicast MAC FDB entry:
AT-9724TS:4# create fdb default 00-00-00-00-01-02 port 2:5
Command: create fdb default 00-00-00-00-01-02 port 2:5
S u c c e s s .
A T - 9 7 2 4 T S : 4 #

Allied Telesis AT-9724TS Specifications

General

MAC address table	16000 entries
Packet buffer memory	2 MB
Maximum data transfer rate	88 Gbit/s
Full duplex	Yes
Dimensions (WxDxH)	440 x 210 x 44 mm
Power requirements	100-240V AC/50-60Hz
Management platform	SNMP, RMON
Networking features	IEEE 802.3 10T Ethernet, IEEE 802.3u 100TX Ethernet, IEEE 802.3ab 1000T Ethernet, IEEE 802.3z 1000X Ethernet
Connectivity technology	Wired
DHCP features	DHCP client
Security algorithms	SSH
Switch type	Managed
Switch layer	L3+
SFP/SFP+ slots quantity	4
Basic switching RJ-45 Ethernet ports quantity	24
Memory type	SDRAM / Flash
Flash memory	16 MB
Internal memory	256 MB
Power consumption (typical)	90 W
Certification	UL 1950 FCC Class A CSA 22.2 No. 950 EN55022 Class A EN 60950 (TUV) EN50082-1 CE
Storage temperature (T-T)	-25 - 55 °C
Operating temperature (T-T)	0 - 40 °C

Weight and Dimensions

Weight	3200 g