Allied Telesis AT-9724TS Reference Manual

create iproute default
Purpose Used to create IP route entries to the Switch’s IP routing table.
Syntax create iproute default <ipaddr> {<metric>}
Description This command is used to remove a VRRP router running on a local device.
Parameters <metric> – Allows the entry of a routing protocol metric entry representing the number of routers between
the Switch and the IP address above.The default setting is 1.
Restrictions Only administrator-level users can issue this command.
Example usage:
To add the default static address 10.48.74.121, with a metric setting of 1, to the routing table:
AT-9724TS:4# create iproute default 10.48.74.121 1
Command: create iproute default 10.48.74.121 1
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
delete iproute
Purpose Used to delete an IP route entry from the Switch’s IP routing table.
Syntax delete iproute default <network_address> <ipaddr> [primary | backup]
Description This command will delete an existing entry from the Switch’s IP routing table.
Parameters <network_address> – IP address and netmask of the IP interface that is the destination of the route.The address
and mask information can be specified using the traditional format (for example, 10.1.2.3/255.0.0.0 or in CIDR
format, 10.1.2.3/8).
<ipaddr> – The gateway IP address for the next hop router.
Restrictions Only administrator-level users can issue this command.
Example usage:
To delete a backup static address 10.48.75.121, mask 255.0.0.0 and gateway (ipaddr) entry of 10.1.1.254 from the routing table:
AT-9724TS:4# delete iproute 10.48.74.121/8 10.1.1.254
Command: delete iproute 10.48.74.121/8 10.1.1.254
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
221
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual

Allied Telesis AT-9724TS Specifications

General

MAC address table	16000 entries
Packet buffer memory	2 MB
Maximum data transfer rate	88 Gbit/s
Full duplex	Yes
Dimensions (WxDxH)	440 x 210 x 44 mm
Power requirements	100-240V AC/50-60Hz
Management platform	SNMP, RMON
Networking features	IEEE 802.3 10T Ethernet, IEEE 802.3u 100TX Ethernet, IEEE 802.3ab 1000T Ethernet, IEEE 802.3z 1000X Ethernet
Connectivity technology	Wired
DHCP features	DHCP client
Security algorithms	SSH
Switch type	Managed
Switch layer	L3+
SFP/SFP+ slots quantity	4
Basic switching RJ-45 Ethernet ports quantity	24
Memory type	SDRAM / Flash
Flash memory	16 MB
Internal memory	256 MB
Power consumption (typical)	90 W
Certification	UL 1950 FCC Class A CSA 22.2 No. 950 EN55022 Class A EN 60950 (TUV) EN50082-1 CE
Storage temperature (T-T)	-25 - 55 °C
Operating temperature (T-T)	0 - 40 °C

Weight and Dimensions

Weight	3200 g