Example usage:
To enable the virtual IP address to be pinged:
AT-9724TS:4# enable vrrp
Command: enable vrrp ping
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
disable vrrp
Purpose To disable a VRRP interface configuration.
Syntax disable vrrp {ping}
Description This command will disable the VRRP interface configuration on the Switch.
Parameters {ping} – Adding this parameter to the command will allow the virtual IP address to be pinged from other host
end nodes to verify connectivity.This will only enable the ping connectivity check function.To enable the VRRP
protocol on the Switch, omit this parameter.This command is disabled by default.
Restrictions Only administrator-level users can issue this command.
Example usage:
To disable the VRRP function globally on the Switch:
AT-9724TS:4# disable vrrp
Command: disable vrrp
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
Example usage:
To disable the virtual IP address from being pinged:
AT-9724TS:4# disable vrrp ping
Command: disable vrrp ping
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
215
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual