Allied Telesis AT-9724TS Reference Manual

Preface
Purpose of This Guide
This guide is intended for network administrators who are responsible for installing and maintaining the AT-9724TS Gigabit Switch.
How This Guide is Organized
This guide contains the following chapters and appendices:
C
hapter 1 - Introduction
Chapter 2 - Using the Console CLI
Chapter 3 - Command Syntax
Chapter 4 - Basic Switch Commands
Chapter 5 - Switch Port Commands
Chapter 6 - Port Security Commands
Chapter 7 - Network Management (SNMP) Commands
Chapter 8 - Switch Utility Commands
Chapter 9 - Network Monitoring Commands
Chapter 10 - Multiple Spanning Tree Protocol (MSTP) Commands
Chapter 11 - Forwarding Database Commands
Chapter 12 - Broadcast Storm Control Commands
Chapter 13 - QoS Commands
Chapter 14 - Port Mirroring Commands
Chapter 15 - VLAN Commands
Chapter 16 - Link Aggregation Commands
Chapter 17 - IP Commands (including IP Multinetting)
Chapter 18 - IGMP Commands
Chapter 19 - IGMP Snooping Commands
Chapter 20 - MAC Notification Commands
Chapter 21 - Access Authentication Control Commands
Chapter 22 - SSH Commands
Chapter 23 - SSL Commands
Chapter 24 - 802.1X Commands
Chapter 25 - Access Control List (ACL) Commands
Chapter 26 - Traffic Segmentation Commands
Chapter 27 - Stacking Commands
Chapter 28 - Allied Telesyn Single IP Management Commands
Chapter 29 - Time and SNTP Commands
Chapter 30 - ARP Commands
Chapter 31 - VRRP Commands
Chapter 32 - Routing Table Commands
Chapter 33 - Route Redistribution Commands
Chapter 34 - BOOTP Relay Commands
Chapter 35 - DNS Relay Commands
Chapter 36 - RIP Commands
Chapter 37 - DVMRP Commands
Chapter 38 - PIM Commands
Chapter 39 - IP Multicasting Commands
Chapter 40 - MD5 Configuration Commands
Chapter 41 - OSPF Configuration Commands
Chapter 42 - Route Preference Commands
Chapter 43 - Jumbo Frame Commands
Chapter 44 - Command History List
Appendix A - Technical Specifications
Appendix B - Translated Electrical Safety and Emission Information
3
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual

Allied Telesis AT-9724TS Specifications

General

MAC address table	16000 entries
Packet buffer memory	2 MB
Maximum data transfer rate	88 Gbit/s
Full duplex	Yes
Dimensions (WxDxH)	440 x 210 x 44 mm
Power requirements	100-240V AC/50-60Hz
Management platform	SNMP, RMON
Networking features	IEEE 802.3 10T Ethernet, IEEE 802.3u 100TX Ethernet, IEEE 802.3ab 1000T Ethernet, IEEE 802.3z 1000X Ethernet
Connectivity technology	Wired
DHCP features	DHCP client
Security algorithms	SSH
Switch type	Managed
Switch layer	L3+
SFP/SFP+ slots quantity	4
Basic switching RJ-45 Ethernet ports quantity	24
Memory type	SDRAM / Flash
Flash memory	16 MB
Internal memory	256 MB
Power consumption (typical)	90 W
Certification	UL 1950 FCC Class A CSA 22.2 No. 950 EN55022 Class A EN 60950 (TUV) EN50082-1 CE
Storage temperature (T-T)	-25 - 55 °C
Operating temperature (T-T)	0 - 40 °C

Weight and Dimensions

Weight	3200 g