delete account
Purpose Used to delete an existing user account
Syntax delete account <username>
Description The delete account command deletes a user account that has been created using the create account
command.
Parameters <username>
Restrictions Only Administrator-level users can issue this command.
Example usage:
To delete the user account “System”:
AT-9724TS:4# delete account System
Command:delete account System
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
show config
Purpose Used to display a list of configuration commands entered into the Switch.
Syntax show config [current_config | config_in_NVRAM]
Description This command displays a list of configuration commands entered into the Switch.
Parameters current_config – Entering this parameter will display configurations entered without being saved to NVRAM.
config_in_NVRAM - Entering this parameter will display configurations entered and saved to NVRAM.
Restrictions None.
Example usage:
To view configurations entered on the Switch that were saved to NVRAM:
Command: show config config_in_NVRAM
# - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
# AT-9724TS Configuration
# Firmware: Build 3.00-B13
# Copyright(C) 2004-2007 Allied Telesyn Corporation. All
rights reserved.
# - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
# BASIC
config serial_port baud_rate 115200 auto_logout never
enable telnet 23
enable web 80
enable clipaging
# STORM
config traffic control 1:1-1:26 broadcast disable multicast
disable dlf disable
threshold 128
config traffic control 2:1-2:24 broadcast disable multicast
disable dlf disable
CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a All
18
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual