Example usage:
To create an SNMP user on the Switch:
AT-9724TS:4# create snmp user Allied Telesyn default
encrypted by_password auth md5 auth_password priv none
Command: create snmp user Allied Telesyn default encrypted
by_password auth md5 auth_password priv none
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
delete snmp user
Purpose Used to remove an SNMP user from an SNMP group and also to delete the associated SNMP group.
Syntax delete snmp user <SNMP_name 32>
Description The delete snmp user command removes an SNMP user from its SNMP group and then deletes the
associated SNMP group.
Parameters <SNMP_name 32> – An alphanumeric string of up to 32 characters that identifies the SNMP user that will be
deleted.
Restrictions Only administrator-level users can issue this command.
Example usage:
To delete a previously entered SNMP user on the Switch:
AT-9724TS:4# delete snmp user Allied Telesyn
Command: delete snmp user Allied Telesyn
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
show snmp user
Purpose Used to display information about each SNMP username in the SNMP group username table.
Syntax show snmp user
Description The show snmp user command displays information about each SNMP username in the SNMP group
username table.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example usage:
To display the SNMP users currently configured on the Switch:
AT-9724TS:4# show snmp user
Command: show snmp user
U s e r n a m e Group Name V e r A u t h P r i v
- - - - - - - - - - - - - - - - - - - - - - - - - - - - -
i n i t i a l i n i t i a l V3 None None
Total Entries: 1
A T - 9 7 2 4 T S : 4 #
35
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual