Chapter 44 - Command History List
The command history list commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following table.
Command Parameters
?
show command_history
config command_history <value 1-40>
Each command is listed, in detail, in the following sections.
?
Purpose Used to display all commands in the Command Line Interface (CLI).
Syntax ?
Description This command will display all of the commands available through the Command Line Interface (CLI).
Parameters None.
Restrictions None.
Example usage:
To display all of the commands in the CLI:
AT-9724TS:4# show command_history
Command: show command_history
. .
?
c l e a r
clear arptable
clear counters
clear fdb
clear log
config 802.1p default_priority
config 802.1p user_priority
config 802.1x auth_mode
config 802.1x auth_parameter ports
config 802.1x auth_protocol
config 802.1x capability ports
config 802.1x init
config access profile profile_id
config all_boxes_id
config arp_aging time
config authen_application
CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a All
A T - 9 7 2 4 T S : 4 #
273
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual