Chapter 9 - Network Monitoring Commands
The network monitoring commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following table.
Command Parameters
show packet ports <portlist>
show error ports <portlist>
show utilization [ports | cpu]
clear counters ports <portlist>
clear log <ipaddr> {times <value 1-255>} {timeout <sec 1-99>}
show log index <value_list>
enable syslog
disable syslog
show syslog
create syslog host [<index 1-4> | all] {severity [informational | warning | all] | facility [local0 | local1 | local2 | local3 | local4 |
local5 | local6 | local7] | udp_port <udp_port_number> | ipaddress <ipaddr> | state [enable | disable]}
config syslog host <index 1-4> {severity [informational | warning | all] | facility [local0 | local1 | local2 | local3 | local4 | local5 |
local6 | local7] | udp_port <udp_port_number> | ipaddress <ipaddr> | state [enable | disable]}
config syslog host all {severity [informational | warning | all] | facility [local0 | local1 | local2 | local3 | local4 | local5 | local6 | local7] |
udp_port <udp_port_number> | state [enable | disable]}
delete syslog host [<index 1-4> | all]
show syslog host [<index 1-4>]
Each command is listed, in detail, in the following sections.
55
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual