Allied Telesis AT-9724TS Reference Manual

Chapter 39 - IP Multicasting Commands
The IP multicasting commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following table.
Command Parameters
show ipmc cache {group <group>} {ipaddress <network_address>}
show ipmc {ipif <ipif_name 12> | protocol [inactive | dvmrp | pim}
Each command is listed, in detail, in the following sections:
show ipmc cache
Purpose Used to display the current IP multicast forwarding cache.
Syntax show ipmc cache {group <group>} {ipaddress <network_address>}
Description This command will display the current IP multicast forwarding cache.
Parameters group <group> – The multicast group IP address.
ipaddress <network_address> – The IP address and netmask of the source.The address and mask information can
be specified using the traditional format (for example, 10.1.2.3/255.0.0.0 or in CIDR format, 10.1.2.3/8).
Restrictions None.
Example usage:
To display the current IP multicast forwarding cache:
AT-9724TS:4# show ipmc cache
Command: show ipmc cache
M u l t i c a s t Source Address/ U p s t r e a m E x p i r e R o u t i n g
G r o u p N e t m a s k N e i g h b o r T i m e P r o t o c o l
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
2 2 4 . 1 . 1 . 1 1 0 . 4 8 . 7 4 . 1 2 1 / 3 2 1 0 . 4 8 . 7 5 . 6 3 3 0 d v m r p
2 2 4 . 1 . 1 . 1 20.48.74.25 /32 2 0 . 4 8 . 7 5 . 2 5 2 0 d v m r p
Total Entries: 3
A T - 9 7 2 4 T S : 4 #
246
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual

Allied Telesis AT-9724TS Specifications

General

MAC address table	16000 entries
Packet buffer memory	2 MB
Maximum data transfer rate	88 Gbit/s
Full duplex	Yes
Dimensions (WxDxH)	440 x 210 x 44 mm
Power requirements	100-240V AC/50-60Hz
Management platform	SNMP, RMON
Networking features	IEEE 802.3 10T Ethernet, IEEE 802.3u 100TX Ethernet, IEEE 802.3ab 1000T Ethernet, IEEE 802.3z 1000X Ethernet
Connectivity technology	Wired
DHCP features	DHCP client
Security algorithms	SSH
Switch type	Managed
Switch layer	L3+
SFP/SFP+ slots quantity	4
Basic switching RJ-45 Ethernet ports quantity	24
Memory type	SDRAM / Flash
Flash memory	16 MB
Internal memory	256 MB
Power consumption (typical)	90 W
Certification	UL 1950 FCC Class A CSA 22.2 No. 950 EN55022 Class A EN 60950 (TUV) EN50082-1 CE
Storage temperature (T-T)	-25 - 55 °C
Operating temperature (T-T)	0 - 40 °C

Weight and Dimensions

Weight	3200 g