Allied Telesis AT-9724TS Reference Manual

disable snmp traps
Purpose Used to disable SNMP trap support on the Switch.
Syntax disable snmp traps
Description This command is used to disable SNMP trap support on the Switch.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example usage:
To prevent SNMP traps from being sent from the Switch:
AT-9724TS:4# disable snmp traps
Command: disable snmp traps
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
disable snmp authenticate_traps
Purpose Used to disable SNMP authentication trap support.
Syntax disable snmp authenticate_traps
Description This command is used to disable SNMP authentication support on the Switch.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example usage:
To disable the SNMP authentication trap support::
AT-9724TS:4# disable snmp authenticate_traps
Command: disable snmp authenticate_traps
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
config snmp system_contact
Purpose Used to enter the name of a contact person who is responsible for the Switch.
Syntax config snmp system_contact{<sw_contact>}
Description The config snmp system_contact command is used to enter the name and/or other information to
identify a contact person who is responsible for the Switch.A maximum of 255 character can be used.
Parameters <sw_contact> – A maximum of 255 characters is allowed.A NULL string is accepted if there is no contact.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure the Switch contact to “MIS Department II”:
AT-9724TS:4# config snmp system_contact richard
Command:config snmp system_contact richard
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
47
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual

Allied Telesis AT-9724TS Specifications

General

MAC address table	16000 entries
Packet buffer memory	2 MB
Maximum data transfer rate	88 Gbit/s
Full duplex	Yes
Dimensions (WxDxH)	440 x 210 x 44 mm
Power requirements	100-240V AC/50-60Hz
Management platform	SNMP, RMON
Networking features	IEEE 802.3 10T Ethernet, IEEE 802.3u 100TX Ethernet, IEEE 802.3ab 1000T Ethernet, IEEE 802.3z 1000X Ethernet
Connectivity technology	Wired
DHCP features	DHCP client
Security algorithms	SSH
Switch type	Managed
Switch layer	L3+
SFP/SFP+ slots quantity	4
Basic switching RJ-45 Ethernet ports quantity	24
Memory type	SDRAM / Flash
Flash memory	16 MB
Internal memory	256 MB
Power consumption (typical)	90 W
Certification	UL 1950 FCC Class A CSA 22.2 No. 950 EN55022 Class A EN 60950 (TUV) EN50082-1 CE
Storage temperature (T-T)	-25 - 55 °C
Operating temperature (T-T)	0 - 40 °C

Weight and Dimensions

Weight	3200 g