Allied Telesis AT-9724TS Reference Manual

config ssl cachetimeout timeout
Purpose Used to configure the SSL cache timeout.
Syntax config ssl cachetimeout timeout <value 60-86400>
Description This command will set the time between a new key exchange between a client and a host using the SSL
function.A new SSL session is established every time the client and host go through a key exchange. Specifying a
longer timeout will allow the SSL session to reuse the master key on future connections with that particular
host, therefore speeding up the negotiation process.
Parameters timeout <value 60-86400> – Enter a timeout value between 60 and 86400 seconds to specify the total time an
SSL key exchange ID stays valid before the SSL module will require a new, full SSL negotiation for connection.
The default cache timeout is 600 seconds.
Restrictions Only administrator-level users can issue this command.
Example usage:
To set the SSL cachetimeout for 7200 seconds:
AT-9724TS:4# config ssl cachetimeout timeout 7200
Command: config ssl cachetimeout timeout 7200
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
show ssl cachetimeout
Purpose Used to show the SSL cache timeout.
Syntax show ssl cachetimeout
Description Entering this command will allow the user to view the SSL cache timeout currently implemented on the Switch.
Parameters None.
Restrictions None.
Example usage:
To view the SSL cache timeout on the Switch:
AT-9724TS:4# show ssl cachetimeout
Command: show ssl cachetimeout
Cache timeout is 600 second(s).
A T - 9 7 2 4 T S : 4 #
164
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual

Allied Telesis AT-9724TS Specifications

General

MAC address table	16000 entries
Packet buffer memory	2 MB
Maximum data transfer rate	88 Gbit/s
Full duplex	Yes
Dimensions (WxDxH)	440 x 210 x 44 mm
Power requirements	100-240V AC/50-60Hz
Management platform	SNMP, RMON
Networking features	IEEE 802.3 10T Ethernet, IEEE 802.3u 100TX Ethernet, IEEE 802.3ab 1000T Ethernet, IEEE 802.3z 1000X Ethernet
Connectivity technology	Wired
DHCP features	DHCP client
Security algorithms	SSH
Switch type	Managed
Switch layer	L3+
SFP/SFP+ slots quantity	4
Basic switching RJ-45 Ethernet ports quantity	24
Memory type	SDRAM / Flash
Flash memory	16 MB
Internal memory	256 MB
Power consumption (typical)	90 W
Certification	UL 1950 FCC Class A CSA 22.2 No. 950 EN55022 Class A EN 60950 (TUV) EN50082-1 CE
Storage temperature (T-T)	-25 - 55 °C
Operating temperature (T-T)	0 - 40 °C

Weight and Dimensions

Weight	3200 g