Allied Telesis AT-9724TS Reference Manual

clear fdb
Purpose Used to clear the Switch’s forwarding database of all dynamically learned MAC addresses.
Syntax clear fdb [vlan <vlan_name 32> | port <port> | all]
Description This command is used to clear dynamically learned entries to the Switch’s forwarding database.
Parameters vlan<vlan_name 32> – The name of the VLAN on which the MAC address resides.
port <port> – The port number corresponding to the MAC destination address.The Switch will always forward
traffic to the specified device through this port.The port is specified by listing the switch number and the port
number on that switch, separated by a colon. For example, 1:3 specifies switch number 1, port 3. 2:4 specifies
switch number 2, port 4.
all – Clears all dynamic entries to the Switch’s forwarding database.
Restrictions Only administrator-level users can issue this command.
Example usage:
To delete a permanent FDB entry:
AT-9724TS:4# clear fdb all
Command: clear fdb all
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
show multicast_fdb
Purpose Used to display the contents of the Switch’s multicast forwarding database.
Syntax show multicast_fdb [vlan <vlan_name 32> | mac_address <macaddr>]
Description This command is used to display the current contents of the Switch’s multicast MAC address forwarding
database.
Parameters <vlan_name 32> – The name of the VLAN on which the MAC address resides.
<macaddr> – The MAC address that is present in the forwarding database table.
Restrictions None.
Example usage:
To delete a permanent FDB entry:
AT-9724TS:4# show multicast_fdb
Command: show multicast_fdb
VLAN Name : default
MAC Address : 01-00-5E-00-00-00
Egress Ports : 1:1-1:5,1:26,2:26
M o d e : Static
Total Entries : 1
A T - 9 7 2 4 T S : 4 #
82
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual

Allied Telesis AT-9724TS Specifications

General

MAC address table	16000 entries
Packet buffer memory	2 MB
Maximum data transfer rate	88 Gbit/s
Full duplex	Yes
Dimensions (WxDxH)	440 x 210 x 44 mm
Power requirements	100-240V AC/50-60Hz
Management platform	SNMP, RMON
Networking features	IEEE 802.3 10T Ethernet, IEEE 802.3u 100TX Ethernet, IEEE 802.3ab 1000T Ethernet, IEEE 802.3z 1000X Ethernet
Connectivity technology	Wired
DHCP features	DHCP client
Security algorithms	SSH
Switch type	Managed
Switch layer	L3+
SFP/SFP+ slots quantity	4
Basic switching RJ-45 Ethernet ports quantity	24
Memory type	SDRAM / Flash
Flash memory	16 MB
Internal memory	256 MB
Power consumption (typical)	90 W
Certification	UL 1950 FCC Class A CSA 22.2 No. 950 EN55022 Class A EN 60950 (TUV) EN50082-1 CE
Storage temperature (T-T)	-25 - 55 °C
Operating temperature (T-T)	0 - 40 °C

Weight and Dimensions

Weight	3200 g