Allied Telesis AT-9724TS Reference Manual

Chapter 12 - Broadcast Storm Control Commands
The broadcast storm control commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following table.
Command Parameters
config traffic control [<storm_grouplist> | all ] { broadcast [enable | disable] | multicast [enable | disable] | dlf [enable | disable] |
threshold <value 0-255> }
show traffic control {group_list <storm_grouplist>}
Each command is listed, in detail, in the following sections:
config traffic control
Purpose Used to configure broadcast/multicast traffic control.
Syntax config traffic control [<storm_grouplist> | all] {broadcast [enable | disable] | multicast
[enable | disable] | dlf [enable | disable] | threshold <value 0-255>}
Description This command is used to configure broadcast storm control.
Parameters <storm_grouplist> – Used to specify a broadcast storm control group.This is specified by listing the lowest
switch number and the beginning port number on that switch, separated by a colon.Then the highest switch
number, and the highest port number of the range (also separated by a colon) are specified.The beginning and
end of the port list range are separated by a dash. For example, 1:3 specifies switch number 1, port 3. 2:4
specifies switch number 2, port 4. 1:3-2:4 specifies all of the ports between switch 1, port 3 and switch 2, port 4
– in numerical order.
all – Specifies all broadcast storm control groups on the Switch.
broadcast [enable | disable] – Enables or disables broadcast storm control.
multicast [enable | disable] – Enables or disables multicast storm control.
dlf [enable | disable] – Enables or disables dlf traffic control.
threshold <value 0-255> – The upper threshold at which the specified traffic control is switched on.The <value>
is the number of broadcast/multicast/dlf packets, in kilopackets per second (Kpps), received by the Switch that
will trigger the storm traffic control measures.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure traffic control and enable broadcast storm control system wide:
AT-9724TS:4# config traffic control all broadcast enable
Command: config traffic control all broadcast enable
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
88
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual

Allied Telesis AT-9724TS Specifications

General

MAC address table	16000 entries
Packet buffer memory	2 MB
Maximum data transfer rate	88 Gbit/s
Full duplex	Yes
Dimensions (WxDxH)	440 x 210 x 44 mm
Power requirements	100-240V AC/50-60Hz
Management platform	SNMP, RMON
Networking features	IEEE 802.3 10T Ethernet, IEEE 802.3u 100TX Ethernet, IEEE 802.3ab 1000T Ethernet, IEEE 802.3z 1000X Ethernet
Connectivity technology	Wired
DHCP features	DHCP client
Security algorithms	SSH
Switch type	Managed
Switch layer	L3+
SFP/SFP+ slots quantity	4
Basic switching RJ-45 Ethernet ports quantity	24
Memory type	SDRAM / Flash
Flash memory	16 MB
Internal memory	256 MB
Power consumption (typical)	90 W
Certification	UL 1950 FCC Class A CSA 22.2 No. 950 EN55022 Class A EN 60950 (TUV) EN50082-1 CE
Storage temperature (T-T)	-25 - 55 °C
Operating temperature (T-T)	0 - 40 °C

Weight and Dimensions

Weight	3200 g