Allied Telesis AT-9724TS Reference Manual

show snmp host
Purpose Used to display the recipient of SNMP traps generated by the Switch’s SNMP agent.
Syntax show snmp host {<ipaddr>}
Description The show snmp host command is used to display the IP addresses and configuration information of remote
SNMP managers that are designated as recipients of SNMP traps that are generated by the Switch’s SNMP
agent
Parameters <ipaddr> – The IP address of a remote SNMP manager that will receive SNMP traps generated by the Switch’s
SNMP agent.
Restrictions None.
Example usage:
To display the currently configured SNMP hosts on the Switch:
AT-9724TS:4# show snmp host
Command: show snmp host
SNMP Host Table
Host IP Address SNMP Version Community Name/
SNMPv3 User Name
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
1 0 . 4 8 . 7 6 . 2 3 V 2 c p r i v a t e
1 0 . 4 8 . 7 4 . 1 0 0 V3 authpriv p u b l i c
Total Entries: 2
A T - 9 7 2 4 T S : 4 #
create trusted_host
Purpose Used to create the trusted host.
Syntax create trusted_host <ipaddr>
Description The create trusted_host command creates the trusted host.The Switch allows you to specify up to four IP
addresses that are allowed to manage the Switch via in-band SNMP or TELNET based management software.
These IP addresses must be members of the Management VLAN. If no IP addresses are specified, then there is
nothing to prevent any IP address from accessing the Switch, provided the user knows the Username and
Password.
Parameters <ipaddr> – The IP address of the trusted host.
Restrictions Only administrator-level users can issue this command.
Example usage:
To create the trusted host:
AT-9724TS:4# create trusted_host 10.48.74.121
Command: create trusted_host 10.48.74.121
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
44
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual

Allied Telesis AT-9724TS Specifications

General

MAC address table	16000 entries
Packet buffer memory	2 MB
Maximum data transfer rate	88 Gbit/s
Full duplex	Yes
Dimensions (WxDxH)	440 x 210 x 44 mm
Power requirements	100-240V AC/50-60Hz
Management platform	SNMP, RMON
Networking features	IEEE 802.3 10T Ethernet, IEEE 802.3u 100TX Ethernet, IEEE 802.3ab 1000T Ethernet, IEEE 802.3z 1000X Ethernet
Connectivity technology	Wired
DHCP features	DHCP client
Security algorithms	SSH
Switch type	Managed
Switch layer	L3+
SFP/SFP+ slots quantity	4
Basic switching RJ-45 Ethernet ports quantity	24
Memory type	SDRAM / Flash
Flash memory	16 MB
Internal memory	256 MB
Power consumption (typical)	90 W
Certification	UL 1950 FCC Class A CSA 22.2 No. 950 EN55022 Class A EN 60950 (TUV) EN50082-1 CE
Storage temperature (T-T)	-25 - 55 °C
Operating temperature (T-T)	0 - 40 °C

Weight and Dimensions

Weight	3200 g