show trusted_host
Purpose Used to display a list of trusted hosts entered on the Switch using the create trusted_host command
above.
Syntax show trusted_host
Description This command is used to display a list of trusted hosts entered on the Switch using the create
trusted_host command above.
Parameters None.
Restrictions None.
Example usage:
To display the list of trusted hosts:
AT-9724TS:4# show trusted_host
Command: show trusted_host
Management Stations
I P A d d r e s s
- - - - - - - - - -
1 0 . 5 3 . 1 3 . 9 4
Total Entries: 1
A T - 9 7 2 4 T S : 4 #
delete trusted_host
Purpose Used to delete a trusted host entry made using the create trusted_host command above.
Syntax delete trusted _host <ipaddr>
Description This command is used to delete a trusted host entry made using the create trusted_host command above.
Parameters <ipaddr> – The IP address of the trusted host.
Restrictions Only administrator-level users can issue this command.
Example usage:
To delete a trusted host with an IP address 10.48.74.121:
AT-9724TS:4# delete trusted_host 10.48.74.121
Command: delete trusted_host 10.48.74.121
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
45
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual