config snmp system_location
Purpose Used to enter a description of the location of the Switch.
Syntax config snmp system_location {<sw_location>}
Description The config snmp system_location command is used to enter a description of the location of the Switch.
A maximum of 255 characters can be used.
Parameters <sw_location> – A maximum of 255 characters is allowed.A NULL string is accepted if there is no location
desired.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure the Switch contact to “
HQ 5F
”:
AT-9724TS:4# config snmp system_location HQ 5F
Command: config snmp system_location HQ 5F
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
config snmp system_name
Purpose Used to configure the name for the Switch.
Syntax config snmp system_name {<sw_name>}
Description The config snmp system_name command configures the name of the Switch.
Parameters <sw_name> – A maximum of 255 characters is allowed.A NULL string is accepted if no name is desired.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure the Switch name for “AT-9724TS Stackable Switch”:
AT-9724TS:4# config snmp system_name AT-9724TS Stackable
S w i t c h
Command: config snmp system_name AT-9724TS Stackable Switch
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
48
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual