show rip
Purpose Used to display the RIP configuration and statistics for the Switch.
Syntax show rip {ipif_name 12>}
Description This command will display the RIP configuration and statistics for a given IP interface or for all IP interfaces.
Parameters ipif <ipif_name 12> – The name of the IP interface for which you want to display the RIP configuration and
settings. If this parameter is not specified, the show rip command will display the global RIP configuration for
the Switch.
Restrictions None.
Example usage:
To display RIP configuration:
AT-9724TS:4# show rip
Command: show rip
R I P Global State : D i s a b l e d
R I P Interface Settings
I n t e r f a c e I P A d d r e s s T X M o d e R X M o d e A u t h e n - S t a t e
t i c a t i o n
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
S y s t e m 1 0 . 4 1 . 4 4 . 3 3 / 8 D i s a b l e d D i s a b l e d D i s a b l e d D i s a b l e d
Total Entries: 1
A T - 9 7 2 4 T S : 4 #
238
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual