Commands Parameters
enable sim
disable sim
show sim {[candidates {<candidate_id 1-100>} | members { <member_id 1-32> } | group {commander_mac <macaddr>}
| neighbor]}
reconfig {member_id <value 1-32> | exit}
config sim_group [add <candidate_id 1-100> {<password>} | delete <member_id 1-32> ]
config sim [{[commander { group_name <groupname 64> | candidate] | dp_interval <sec 30-90> | hold_time <sec 100-
255>}
download sim_ms [firmware | configuration] <ipaddr> <path_filename> [members <mslist 1-32> | all}
upload sim_ms configuration <ipaddr> <path_filename> <member_id 1-32>
Each command is listed, in detail, in the following sections.
enable sim
Purpose Used to enable Single IP Management (SIM) on the Switch.
Syntax enable sim
Description This command will enable SIM globally on the Switch. SIM features and functions will not function properly
unless this function is enabled.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example usage:
To enable SIM on the Switch:
AT-9724TS:4# enable sim
Command: enable sim
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
disable sim
Purpose Used to disable Single IP Management (SIM) on the Switch.
Syntax disable sim
Description This command will disable SIM globally on the Switch.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example usage:
To enable SIM on the Switch:
AT-9724TS:4# disable sim
Command: disable sim
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
197
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual