Allied Telesis AT-9724TS Reference Manual

config bootp_relay delete
Purpose Used to delete an IP destination address from the Switch’s BOOTP relay table.
Syntax config bootp_relay delete ipif <ipif_name 12> <ipaddr>
Description This command is used to delete an IP destination addresses in the Switch’s BOOTP relay table.
Parameters <ipif_name 12> – The name of the IP interface that contains the IP address below.
<ipaddr> – The BOOTP server IP address.
Restrictions Only administrator-level users can issue this command.
Example usage:
To delete a bootp relay:
AT-9724TS:4# config bootp_relay delete ipif System
1 0 . 4 3 . 2 1 . 1 2
Command: config bootp_relay delete ipif System 10.43.21.12
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
enable bootp_relay
Purpose Used to enable the BOOTP relay function on the Switch.
Syntax enable bootp_relay
Description This command, in combination with the disable bootp_relay command below, is used to enable and disable
the BOOTP relay function on the Switch.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example usage:
To enable the bootp relay function:
AT-9724TS:4# enable bootp_relay
Command: enable bootp_relay
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
230
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual

Allied Telesis AT-9724TS Specifications

General

MAC address table	16000 entries
Packet buffer memory	2 MB
Maximum data transfer rate	88 Gbit/s
Full duplex	Yes
Dimensions (WxDxH)	440 x 210 x 44 mm
Power requirements	100-240V AC/50-60Hz
Management platform	SNMP, RMON
Networking features	IEEE 802.3 10T Ethernet, IEEE 802.3u 100TX Ethernet, IEEE 802.3ab 1000T Ethernet, IEEE 802.3z 1000X Ethernet
Connectivity technology	Wired
DHCP features	DHCP client
Security algorithms	SSH
Switch type	Managed
Switch layer	L3+
SFP/SFP+ slots quantity	4
Basic switching RJ-45 Ethernet ports quantity	24
Memory type	SDRAM / Flash
Flash memory	16 MB
Internal memory	256 MB
Power consumption (typical)	90 W
Certification	UL 1950 FCC Class A CSA 22.2 No. 950 EN55022 Class A EN 60950 (TUV) EN50082-1 CE
Storage temperature (T-T)	-25 - 55 °C
Operating temperature (T-T)	0 - 40 °C

Weight and Dimensions

Weight	3200 g