enable dnsr
Purpose Used to enable the DNS relay.
Syntax enable dnsr {cache | static}
Description This command is used, in combination with the disable dnsr command below, to enable and disable DNS
Relay on the Switch.
Parameters cache – This parameter will allow the user to enable the cache lookup for the DNS rely on the Switch.
static – This parameter will allow the user to enable the static table lookup for the DNS rely on the Switch.
Restrictions Only administrator-level users can issue this command.
Example usage:
To enable status of DNS relay.
AT-9724TS:4# enable dnsr
Command: enable dnsr
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
Example usage:
To enable cache lookup for DNS relay.
AT-9724TS:4# enable dnsr cache
Command: enable dnsr cache
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
Example usage:
To enable static table lookup for DNS relay.
AT-9724TS:4# enable dnsr static
Command: enable dnsr static
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
233
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual