AudioCodes Media 800 MSBR

User's Manual 178 Document #: LTRT-12809
Mediant 800 MSBR
SEM indicating this change. If the value changes to 3.3, it sends a yellow state (i.e.,
medium quality); if the value changes to 3.5, it sends a green state.
4. Configure the parameters as required. See the table below for a description of each
parameter.
5. Click Submit to apply your settings.
Quality of Experience Parameter Descriptions
Parameter Description
Index
CLI: index
[QOERules_RuleIndex]
Defines the table index entry. Up to four table row entries can be
configured per Media Realm.
Monitored Parameter
CLI: monitored-parameter
[QOERules_MonitoredParam]
Defines the parameter to monitor and report.
 [0] MOS (default)
 [1] Delay
 [2] Packet Loss
 [3] Jitter
 [4] RERL
Direction
CLI: direction
[QOERules_Direction]
Defines the monitoring direction.
 [0] Device Side (default)
 [1] Remote Side
Profile
CLI: profile
[QOERules_Profile]
Defines the pre-configured threshold profile to use.
 [0] No Profile = No profile is used and you need to define the
thresholds in the parameters described below.
 [1] Low Sensitivity = Automatically sets the thresholds to low
sensitivity values. Therefore, reporting is done only if changes
in parameters' values is significant.
 [2] Default Sensitivity = Automatically sets the thresholds to a
medium sensitivity.
 [3]
High Sensitivity = Automatically sets the thresholds to high
sensitivity values. Therefore, reporting is done for small
fluctuations in parameters' values.
Green Yellow Threshold
CLI: green-yellow-threshold
[QOERules_GreenYellowThres
hold]
Defines the parameter threshold values between green (good
quality) and yellow (medium quality) states.
Green Yellow Hysteresis
CLI: green-yellow-hysteresis
[QOERules_GreenYellowHyste
rsis]
Defines the hysteresis (fluctuation) for the green-yellow
threshold. When the threshold is exceeded by this hysteresis
value, the device sends a report to the SEM indicating this
change.
Yellow Red Threshold
CLI: yellow-red-threshold
[QOERules_YellowRedThresho
ld]
Defines the parameter threshold values between yellow (medium
quality) and red (poor quality). When this threshold is exceeded,
the device sends a report to the SEM indicating this change.
Yellow Red Hysteresis
CLI: yellow-red-hysteresis
[QOERules_YellowRedHystersi
s]
Defines the hysteresis (fluctuation) for the yellow-red threshold.
When the threshold is exceeded by this hystersis value, the
device sends a report to the SEM indicating this change.