Parameter Description
SRD
CLI: srd
[IPGroup_SRD]
Assigns an SRD to the IP Group.
The default is 0.
Notes:
For this parameter to take effect, a device reset is required.
To configure SRDs, see Configuring SRD Table on page 205.
For Server-type IP Groups, if you assign the IP Group with a Proxy
Set ID (in the 'Proxy Set ID' field), the SRD field is automatically set to
the SRD value assigned to the Proxy Set in the Proxy Set table.
Media Realm Name
CLI: media-realm-name
[IPGroup_MediaRealm]
Assigns a Media Realm to the IP Group. The string value must be
identical (including case-sensitive) to the Media Realm name defined in
the Media Realm table.
Notes:
For this parameter to take effect, a device reset is required.
If the Media Realm is later deleted from the Media Realm table, then
this value becomes invalid.
For configuring Media Realms, see Configuring Media Realms on
page 174.
IP Profile ID
CLI: ip-profile-id
[IPGroup_ProfileId]
Assigns an IP Profile to the IP Group.
The default is 0.
Note: To configure IP Profiles, see 'Configuring IP Profiles' on page 245.
Gateway Parameters
Always Use Route Table
CLI: always-use-route-
table
[IPGroup_AlwaysUseRo
uteTable]
Defines the Request-URI host name in outgoing INVITE messages.
[0] No (default).
[1] Yes = The device uses the IP address (or domain name) defined
in the Outbound IP Routing Table (see Configuring the Outbound IP
Routing Table on page 327) as the Request-URI host name in
outgoing INVITE messages, instead of the value configured in the
'SIP Group Name' field.
Note: This parameter is applicable only to Server-type IP Groups.
Routing Mode
CLI: routing-mode
[IPGroup_RoutingMode]
Defines the routing mode for outgoing SIP INVITE messages.
[-1] Not Configured = (Default) The routing is according to the
selected Serving IP Group. If no Serving IP Group is selected, the
device routes the call according to the Outbound IP Routing Table
(see Configuring Outbound IP Routing Table on page 327).
[0] Routing Table = The device routes the call according to the
Outbound IP Routing Table.
[1] Serving IP Group = The device sends the SIP INVITE to the
selected Serving IP Group. If no Serving IP Group is selected, the
default IP Group is used. If the Proxy server(s) associated with the
destination IP Group is not alive, the device uses the Outbound IP
Routing Table (if the parameter IsFallbackUsed is set 1, i.e., fallback
enabled - see 'Configuring Proxy and Registration Parameters' on
page 228).
[2] Request-URI = The device sends the SIP INVITE to the IP
address according to the received SIP Request-URI host name.
Notes:
This parameter is applicable only to the IP-to-IP application.
This parameter is applicable only to Server-type IP Groups.
To Next Page
Loading...
