AudioCodes Media 800 MSBR - Page 217

Version 6.6 217 Mediant 800 MSBR
User's Manual 19. Control Network
Parameter Description

[9] P-Called-Party-ID
 [10] Contact
Notes:
 This parameter is applicable only when classification is done
according to the Classification table.
 If the configured SIP header does not exist in the incoming INVITE
message, the classification of the message to a source IP Group fails.
 If the device receives an INVITE as a result of a REFER request or a
3xx response, then the incoming INVITE is routed according to the
Request-URI. The device identifies such INVITEs according to a
specific prefix in the Request-URI header, configured by the
SBCXferPrefix parameter. Therefore, in this scenario, the device
ignores this parameter setting.
Destination URI Input
CLI: dst-uri-input
[IPGroup_DestUriInput]
Defines the SIP header in the incoming INVITE used for call matching
characteristics based on destination URIs.
 [-1] Not Configured (default)
 [0] From
 [1] To
 [2] Request-URI
 [3] P-Asserted - First Header
 [4] P-Asserted - Second Header
 [5] P-Preferred
 [6] Route
 [7] Diversion
 [8] P-Associated-URI
 [9] P-Called-Party-ID
 [10] Contact
Notes:
 This parameter is applicable only when classification is done
according to the Classification table.
 If the configured SIP header does not exist in the incoming INVITE
message, the classification of the message to a source IP Group fails.
 If the device receives an INVITE as a result of a REFER request or a
3xx response, then the incoming INVITE is routed according to the
Request-URI. The device identifies such INVITEs according to a
specific prefix in the Request-URI header, configured by the
SBCXferPrefix parameter. Therefore, in this scenario, the device
ignores this parameter setting.
Inbound Message
Manipulation Set
CLI: inbound-mesg-
manipulation-set
[IPGroup_InboundManS
et]
Assigns a Message Manipulation Set (rule) to the IP Group for SIP
message manipulation on the inbound message. The Message
Manipulation rules are configured using the MessageManipulations
parameter (see Configuring SIP Message Manipulation on page 232).
Outbound Message
Manipulation Set
CLI: outbound-mesg-
manipulation-set
[IPGroup_OutboundMan
Set]
Message Manipulation Set (rule) that you want to assign to this IP Group
for SIP message manipulation on the outbound message. The Message
Manipulation rules are configured using the MessageManipulations
parameter (see Configuring SIP Message Manipulation on page 232).