AudioCodes Media 800 MSBR - Page 216

User's Manual 216 Document #: LTRT-12809
Mediant 800 MSBR
Parameter Description
are set to the value of the ‘SIP Group Name’ parameter defined for the
Serving IP Group.
Notes:
 This parameter is applicable only to the IP-to-IP application.
 If the PreferRouteTable parameter is set to 1, the routing rules in the
Outbound IP Routing Table take precedence over this ‘Serving IP
Group ID’ parameter.
 If this parameter is not configured, the INVITE messages are sent to
the default Proxy or according to the ‘Outbound IP Routing Table.
SBC Parameters
Classify By Proxy Set
CLI: classify-by-proxy-set
[IPGroup_ClassifyByPro
xySet]
Defines whether the incoming INVITE is classified to an IP Group
according to its associated Proxy Set ID.
 [0] Disable
 [1] Enable (default)
This classification occurs only if classification according to the device's
database fails to (i.e., received INVITE is not from a registered user).
The classification proceeds with checking whether the INVITE's IP
address (if host names, then according to the dynamically resolved IP
address list) is defined for a Proxy Set ID (in the Proxy Set table). If a
Proxy Set ID has such an IP address, the device classifies the INVITE as
belonging to the IP Group associated with this Proxy Set. The Proxy Set
ID is assigned to the IP Group using the IP Group table's 'Proxy Set ID'
parameter (see above).
Notes:
 In cases where multiple IP Groups are associated with the same
Proxy Set ID, do not enable this feature. If enabled, the device is
unable to correctly classify the incoming INVITEs to the appropriate
IP Groups.
 To enhance security, it is highly recommended to disable this
parameter so that the device can use the Classification table rules to
classify the call. If this parameter is enabled, the Classification table is
not used if an associated Proxy Set is found.
 This parameter is applicable only to Server-type IP Groups.
Max Number Of
Registered Users
CLI: max-num-of-reg-
users
[IPGroup_MaxNumOfRe
gUsers]
Defines the maximum number of users in this IP Group that can register
with the device. By default, no limitation exists for registered users.
Note: This field is applicable only to User-type IP Groups.
Source URI Input
CLI: src-uri-input
[IPGroup_SourceUriInpu
t]
Defines the SIP header in the incoming INVITE to use for call matching
characteristics based on source URIs.
 [-1] Not Configured (default)
 [0] From
 [1] To
 [2] Request-URI
 [3] P-Asserted - First Header
 [4] P-Asserted - Second Header
 [5] P-Preferred
 [6] Route
 [7] Diversion
 [8] P-Associated-URI