Parameter Description
Web: Second Tx DTMF Option
[IpProfile_SecondTxDtmfOption
]
For a description, see the global parameter TxDTMFOption.
Web: Declare RFC 2833 in SDP
[IpProfile_RxDTMFOption]
For a description, see the global parameter RxDTMFOption.
Web: Add IE In SETUP
[IpProfile_AddIEInSetup]
For a description, see the global parameter AddIEinSetup.
Web: Enable QSIG Tunneling
[IpProfile_EnableQSIGTunnelin
g]
For a description, see the global parameter
EnableQSIGTunneling.
Web: Enable Hold
[IpProfile_EnableHold]
For a description, see the global parameter EnableHold.
[IpProfile_EnableEarly183]
For a description, see the global parameter EnableEarly183.
[IpProfile_EarlyAnswerTimeout]
For a description, see the global parameter
EarlyAnswerTimeout.
SBC Parameters
Web: Transcoding Mode
[IpProfile_TranscodingMode]
For a description, see the global parameter TranscodingMode.
Web: Extension Coders Group ID
[IpProfile_SBCExtensionCoders
GroupID]
Defines the Coder Group ID used for Extended (additional)
coders added to the outgoing leg for this profile. This is used
when transcoding is required between two IP entities (i.e., the
SDP answer from one doesn’t include any coder included in the
offer previously sent by the other). Therefore, to allow IP
entities to communicate with each other regardless of their
capabilities, an Extended coders table with at least one coder
that is supported by each IP entity needs to be assigned to
each IP Group. Therefore, each offer destined to specific IP
Groups includes this coder.
Note: To configure Coders Groups, see Configuring Coder
Groups.
Web: Allowed Coders Group ID
[IpProfile_SBCAllowedCodersG
roupID]
Associates a Coders Group ID for defining the coders that can
be used for this IP entity.
Notes:
For a description of the Allowed Coders feature, see
Restricting Coders.
To configure Allowed Coders Groups, see Configuring
Allowed Coder Groups on page 460.
Web: Allowed Coders Mode
[IpProfile_SBCAllowedCodersM
ode]
Determines the mode of the Allowed Coders feature for this IP
Profile.
[0] Restriction = In the incoming SDP offer, the device uses
only coders that are also listed in the Allowed Coders Group;
the rest are removed from the SDP offer (i.e., only coders
common between SDP offered coders and Allowed Coders
Group are used). If an Extension Coders Group is also
selected (using the IP Profile's
SBCExtensionCodersGroupID parameter), these coders are
added to the SDP offer.
To Next Page
Loading...
