To configure redirect number manipulation rules:
1. Open the required redirect number manipulation table (Configuration tab > VoIP
menu > GW and IP to IP submenu > Manipulations > Redirect Number Tel > IP or
Redirect Number IP > Tel).
2. Click the Add button; the following dialog box appears (e.g., Redirect Number Tel > IP
table):
Figure 25-4: Redirect Number Manipulation (e.g., Tel to IP)
3. Click the Rule tab, and then configure the matching characteristics. For a description
of the parameters, see the table below.
4. Click the Action tab, and then configure the manipulation operation. For a description
of the parameters, see the table below.
5. Click Submit to apply your settings.
Redirect Number Manipulation Parameters Description
Parameter Description
Matching Characteristics (Rule)
Web/EMS: Redirect Prefix
CLI: redirect-prefix
[RedirectPrefix]
Defines the redirect telephone number prefix. To denote any number,
use the wildcard asterisk (*) symbol.
Web/EMS: Destination
Prefix
CLI: dst-prefix
[DestinationPrefix]
Defines the destination (called) telephone number prefix. To denote
any number, use the wildcard asterisk (*) symbol.
For manipulating the diverting and redirected numbers for call
diversion, you can use the strings "DN" and "RN" to denote the
destination prefix of these numbers. For more information, see
Manipulating Redirected and Diverted Numbers for Call Diversion on
page 316.
Web: Source Trunk Group
ID
CLI: src-trunk-group-id
[SrcTrunkGroupID]
Defines the Trunk Group from where the Tel call is received. To
denote any Trunk Group, leave this field empty.
Notes:
This parameter is applicable only to the Redirect Number Tel > IP
table.
The value -1 indicates that this field is ignored in the rule.
For IP-to-IP call routing, this parameter is not relevant.
Source IP Group ID
CLI: src-ip-group-id
[SrcIPGroupID]
Defines the IP Group from where the IP call originated. Typically, the
IP Group of an incoming INVITE is determined or classified by the
Inbound IP Routing Table. If not used (i.e., any IP Group), leave the
field empty.
Notes:
To Next Page
Loading...
