AudioCodes Media 800 MSBR

User's Manual 886 Document #: LTRT-12809
Mediant 800 MSBR
Parameter Description
EnableIp2TelInterworking:
 Disabled: The network-domain field in the Resource-Priority header
is set to "0 1 0 0" (i.e., "routine") in the Precedence Level field.
 Enabled: The network-domain field in the Resource-Priority header
is set in the Precedence Level field according to Table 5.3.2.12-4
(Mapping of RPH r-priority Field to PRI Precedence Level Value).
The domain name can be a string of up to 10 characters.
The format of this table ini file parameter is as follows:
FORMAT ResourcePriorityNetworkDomains_Index =
ResourcePriorityNetworkDomains_Name,
ResourcePriorityNetworkDomains_EnableIp2TelInterworking;
ResourcePriorityNetworkDomains 1 = dsn, 0;
ResourcePriorityNetworkDomains 2 = dod, 0;
ResourcePriorityNetworkDomains 3 = drsn, 0;
ResourcePriorityNetworkDomains 5 = uc, 1;
ResourcePriorityNetworkDomains 7 = cuc, 0;
[ \ResourcePriorityNetworkDomains ]
Notes:

Indices 1, 2, 3, 5, and 7 cannot be modified and are defined for DSN,
DOD, DRSN, UC, and CUC, respectively.
 If the MLPPDefaultNamespace parameter is set to -1, interworking
from PSTN NI digits is done automatically.
Web/EMS: Default Call
Priority
CLI: dflt-call-prio
[SIPDefaultCallPriority]
Determines the default call priority for MLPP calls.
 [0] 0 = (Default) ROUTINE
 [2] 2 = PRIORITY
 [4] 4 = IMMEDIATE
 [6] 6 = FLASH
 [8] 8 = FLASH-OVERRIDE
 [9] 9 = FLASH-OVERRIDE-OVERRIDE
If the incoming SIP INVITE request doesn't contain a valid priority value
in the SIP Resource-Priority header, the default is used in the
Precedence IE (after translation to the relevant ISDN Precedence
value) of the outgoing PRI Setup message.
If the incoming PRI Setup message doesn't contain a valid Precedence
Level value, the default is used in the Resource-Priority header of the
outgoing SIP INVITE request. In this scenario, the character string is
sent without translation to a numerical value.
Web: MLPP DiffServ
EMS: Diff Serv
CLI: mlpp-diffserv
[MLPPDiffserv]
Defines the DiffServ value (differentiated services code point/DSCP)
used in IP packets containing SIP messages that are related to MLPP
calls. This parameter defines DiffServ for incoming and outgoing MLPP
calls with the Resource-Priority header.
The valid range is 0 to 63. The default is 50.
Web/EMS: Preemption
Tone Duration
CLI: preemp-tone-dur
[PreemptionToneDurati
on]
Defines the duration (in seconds) in which the device plays a
preemption tone to the Tel and IP sides if a call is preempted.
The valid range is 0 to 60. The default is 3.
Note: If set to 0, no preemption tone is played.
Web: MLPP Normalized
Service Domain
EMS: Normalized Service
Domain
Defines the MLPP normalized service domain string. If the device
receives an MLPP ISDN incoming call, it uses the parameter (if different
from ‘FFFFFF’) as a Service domain in the SIP Resource-Priority
header in outgoing INVITE messages. If the parameter is configured to