[1] Enable = (Default) Adds the SIP resource-priority tag in the SIP
Require header.
Note: This parameter is applicable only to MLPP priority call handling
(i.e., only when the CallPriorityMode parameter is set to 1).
Multiple Differentiated Services Code Points (DSCP) per MLPP Call Priority Level
(Precedence) Parameters
The MLPP service allows placement of priority calls, where properly validated users can preempt
(terminate) lower-priority phone calls with higher-priority calls. For each MLPP call priority level, the
DSCP can be set to a value from 0 to 63. The Resource Priority value in the Resource-Priority SIP
header can be one of the following:
MLPP Precedence Level Precedence Level in Resource-Priority SIP Header
0 (lowest) routine
2 priority
4 immediate
6 flash
8 flash-override
9 (highest) flash-override-override
Web/EMS: RTP DSCP for
MLPP Routine
CLI: dscp-4-mlpp-rtn
[MLPPRoutineRTPDSCP
]
Defines the RTP DSCP for MLPP Routine precedence call level.
The valid range is -1 to 63. The default is -1.
Note: If set to -1, the DiffServ value is taken from the global parameter
PremiumServiceClassMediaDiffServ or as defined in IP Profiles per call.
Web/EMS: RTP DSCP for
MLPP Priority
CLI: dscp-4-mlpp-prio
[MLPPPriorityRTPDSCP
]
Defines the RTP DSCP for MLPP Priority precedence call level.
The valid range is -1 to 63. The default is -1.
Note: If set to -1, the DiffServ value is taken from the global parameter
PremiumServiceClassMediaDiffServ or as defined in IP Profiles per call.
Web/EMS: RTP DSCP for
MLPP Immediate
CLI: dscp-4-mlpp-immed
[MLPPImmediateRTPDS
CP]
Defines the RTP DSCP for MLPP Immediate precedence call level.
The valid range is -1 to 63. The default is -1.
Note: If set to -1, the DiffServ value is taken from the global parameter
PremiumServiceClassMediaDiffServ or as defined in IP Profiles per call.
Web/EMS: RTP DSCP for
MLPP Flash
CLI: dscp-4-mlpp-flsh
[MLPPFlashRTPDSCP]
Defines the RTP DSCP for MLPP Flash precedence call level.
The valid range is -1 to 63. The default is -1.
Note: If set to -1, the DiffServ value is taken from the global parameter
PremiumServiceClassMediaDiffServ or as defined in IP Profiles per call.
Web/EMS: RTP DSCP for
MLPP Flash Override
CLI: dscp-4-mlpp-flsh-ov
[MLPPFlashOverRTPDS
CP]
Defines the RTP DSCP for MLPP Flash-Override precedence call level.
The valid range is -1 to 63. The default is -1.
Note: If set to -1, the DiffServ value is taken from the global parameter
PremiumServiceClassMediaDiffServ or as defined in IP Profiles per call.
Web/EMS: RTP DSCP for
MLPP Flash-Override-
Override
CLI: dscp-4-mlpp-flsh-ov-
ov
To Next Page
Loading...
