User provided, user provided: the first one is used
Note: When using the ini file to configure the device to support
several ISDNInCallsBehavior features, enter a summation of the
individual feature values. For example, to support both [2048] and
[65536] features, set ISDNInCallsBehavior = 67584 (i.e., 2048 +
65536).
[ISDNInCallsBehavior_x]
Same as the description for the parameter ISDNInCallsBehavior,
but per trunk (i.e., where x denotes the Trunk ID).
Web/EMS: Q.931 Layer
Response Behavior
CLI: isdn-bits-ns-behavior
[ISDNIBehavior]
Bit-field used to determine several behavior options that influence
the behaviour of the Q.931 protocol.
[0] = Disable (default).
[1] NO STATUS ON UNKNOWN IE = Q.931 Status message
isn't sent if Q.931 received message contains an
unknown/unrecognized IE. By default, the Status message is
sent.
Note: This value is applicable only to ISDN variants in which
sending of Status message is optional.
[2] NO STATUS ON INV OP IE = Q.931 Status message isn't
sent if an optional IE with invalid content is received. By
default, the Status message is sent.
Note: This option is applicable only to ISDN variants in which
sending of Status message is optional.
[4] ACCEPT UNKNOWN FAC IE = Accepts
unknown/unrecognized Facility IE. Otherwise, the Q.931
message that contains the unknown Facility IE is rejected
(default).
Note: This option is applicable only to ISDN variants where a
complete ASN1 decoding is performed on Facility IE.
[128] SEND USER CONNECT ACK = The Connect ACK
message is sent in response to received Q.931 Connect;
otherwise, the Connect ACK is not sent.
Note: This option is applicable only to Euro ISDN User side
outgoing calls.
[512] EXPLICIT INTERFACE ID = Enables to configure T1
NFAS Interface ID (refer to the parameter
ISDNNFASInterfaceID_x).
Note: This value is applicable only to 4/5ESS, DMS, NI-2 and
HKT variants.
[2048] ALWAYS EXPLICIT = Always set the Channel
Identification IE to explicit Interface ID, even if the B-channel is
on the same trunk as the D-channel.
Note: This value is applicable only to 4/5ESS, DMS variants.
[32768] ACCEPT MU LAW =Mu-Law is also accepted in ETSI.
[65536] EXPLICIT PRES SCREENING = The calling party
number (octet 3a) is always present even when presentation
and screening are at their default.
Note: This option is applicable only to ETSI, NI-2, and 5ESS.
To Next Page
Loading...
