no action is taken (default).
[262144] STATUS ERROR CAUSE = Clear call on receipt of
Status according to cause value.
[524288] ACCEPT A LAW =A-Law is also accepted in 5ESS.
[2097152] RESTART INDICATION = Upon receipt of a Restart
message, acEV_PSTN_RESTART_CONFIRM is generated.
[4194304] FORCED RESTART = On data link (re)initialization,
send RESTART if there is no call.
[67108864] NS ACCEPT ANY CAUSE = Accept any Q.850
Cause IE from ISDN.
Note: This option is applicable only to Euro ISDN.
[134217728] NS_BRI_DL_ALWAYS_UP (0x08000000) = By
default, the BRI D-channel goes down if there are no active
calls. If this option is configured, the BRI D-channel is always
up and synchronized.
[536870912] Alcatel coding for redirect number and display
name is accepted by the device.
Note: This option is applicable only to QSIG (and relevant for
specific Alcatel PBXs such as OXE).
[1073741824] QSI ENCODE INTEGER = If this bit is set,
INTEGER ASN.1 type is used in operator coding (compliant to
new ECMA standards); otherwise, OBJECT IDENTIFIER
ASN.1 type is used.
Note: This option is applicable only to QSIG.
[2147483648] 5ESS National Mode For Bch Maintenance =
Use the National mode of AT&T 5ESS for B-channel
maintenance.
Notes:
To configure the device to support several ISDNIBehavior
features, enter a summation of the individual feature values.
For example, to support both [512] and [2048] features, set
the parameter ISDNIBehavior is set to 2560 (i.e., 512 + 2048).
When configuring in the Web interface, to select the options
click the arrow button and then for each required option select
1 to enable.
[ISDNIBehavior_x]
Same as the description for parameter ISDNIBehavior, but for a
specific trunk ID.
Web: General Call Control
Behavior
EMS: General CC Behavior
CLI: isdn-bits-cc-behavior
[ISDNGeneralCCBehavior]
Bit-field for determining several general CC behavior options. To
select the options, click the arrow button, and then for each
required option, select 1 to enable. The default is 0 (i.e., disable).
[2] = Data calls with interworking indication use 64 kbps B-
channels (physical only).
[8] REVERSE CHAN ALLOC ALGO = Channel ID allocation
algorithm.
[16] = The device clears down the call if it receives a NOTIFY
message specifying 'User-Suspended'. A NOTIFY (User-
Suspended) message is used by some networks (e.g., in Italy
or Denmark) to indicate that the remote user has cleared the
call, especially in the case of a long distance voice call.
[32] CHAN ID 16 ALLOWED = Applies only to ETSI E1 lines
To Next Page
Loading...
