Parameter Description
CLI: call-re-rte-mode
[CallReroutingMode]
Determines whether ISDN call rerouting (call forward) is performed by
the PSTN instead of by the SIP side. This call forwarding is based on
Call Deflection for Euro ISDN (ETS-300-207-1) and QSIG (ETSI TS 102
393).
[0] Disable (default).
[1] Enable = Enables ISDN call rerouting. When the device sends
the INVITE message to the remote SIP entity and receives a SIP
302 response with a Contact header containing a URI host name
that is the same as the device's IP address, the device sends a
Facility message with a Call Rerouting invoke method to the ISDN
and waits for the PSTN side to disconnect the call.
Note: When this parameter is enabled, ensure that you configure in the
Inbound IP Routing Table (PSTNPrefix ini file parameter) a rule to route
the redirected call (using the user part from the 302 Contact header) to
the same Trunk Group from where the incoming Tel-to-IP call was
received.
EMS: Enable CIC
[EnableCIC]
Determines whether the Carrier Identification Code (CIC) is relayed to
ISDN.
[0] = (Default) Do not relay the Carrier Identification Code (CIC) to
ISDN.
[1] = CIC is relayed to the ISDN in Transit Network Selection (TNS)
IE.
If enabled, the CIC code (received in an INVITE Request-URI) is
included in a TNS IE in the ISDN Setup message.
For example: INVITE sip:555666;cic=2345@100.2.3.4 sip/2.0.
Notes:
This feature is supported only for SIP-to-ISDN calls.
The parameter AddCicAsPrefix can be used to add the CIC as a
prefix to the destination phone number for routing IP-to-Tel calls.
EMS: Enable AOC
[EnableAOC]
Determines whether ISDN Advice of Charge (AOC) messages are
interworked with SIP.
[0] = (Default) Not used.
[1] = AOC messages are interworked to SIP (in receive direction)
and sent to the PSTN in the transmit direction.
The device supports both the receipt and sending of ISDN (Euro ISDN)
AOC messages:
AOC messages can be received during a call (Facility messages) or
at the end of a call (Disconnect or Release messages). The device
converts the AOC messages into SIP INFO (during a call) and BYE
(end of a call) messages, using a proprietary AOC SIP header. The
device supports both Currency and Pulse AOC messages.
AOC messages can be sent during a call (Facility messages) or at
the end of a call (Disconnect or Release messages). This is done by
assigning the Charge Code index to the desired routing rule in the
Outbound IP Routing table. For more information, see 'Advice of
Charge Services for Euro ISDN' on page 394.
Web: IPMedia Detectors
EMS: DSP Detectors
Enable
CLI: IPM-detectors-
To Next Page
Loading...
