[1] Layer 3 Source IP = The actual IP address (Layer 3) from
where the SIP packet was received is used.
Web: Use Source Number
As Display Name
EMS: Display Name
CLI: src-nb-as-disp-name
[UseSourceNumberAsDi
splayName]
Determines the use of Tel Source Number and Display Name for
Tel-to-IP calls.
[0] No = (Default) If a Tel Display Name is received, the Tel
Source Number is used as the IP Source Number and the Tel
Display Name is used as the IP Display Name. If no Display
Name is received from the Tel side, the IP Display Name remains
empty.
[1] Yes = If a Tel Display Name is received, the Tel Source
Number is used as the IP Source Number and the Tel Display
Name is used as the IP Display Name. If no Display Name is
received from the Tel side, the Tel Source Number is used as the
IP Source Number and also as the IP Display Name.
[2] Overwrite = The Tel Source Number is used as the IP Source
Number and also as the IP Display Name (even if the received
Tel Display Name is not empty).
[3] Original = Similar to option [2], except that the operation is
done before regular calling number manipulation.
Web/EMS: Use Display
Name as Source Number
CLI: disp-name-as-src-nb
[UseDisplayNameAsSour
ceNumber]
Determines the use of Source Number and Display Name for IP-to-
Tel calls.
[0] No = (Default) If IP Display Name is received, the IP Source
Number is used as the Tel Source Number and the IP Display
Name is used as the Tel Display Name. If no Display Name is
received from IP, the Tel Display Name remains empty.
[1] Yes = If an IP Display Name is received, it is used as the Tel
Source Number and also as the Tel Display Name, and
Presentation is set to Allowed (0). If no Display Name is received
from IP, the IP Source Number is used as the Tel Source Number
and Presentation is set to Restricted (1).
For example: When 'From: 100 <sip:200@201.202.203.204>' is
received, the outgoing Source Number and Display Name are set to
'100' and the Presentation is set to Allowed (0).
When 'From: <sip:100@101.102.103.104>' is received, the outgoing
Source Number is set to '100' and the Presentation is set to
Restricted (1).
Web: Use Routing Table
for Host Names and
Profiles
EMS: Use Routing Table
For Host Names
CLI: rte-tbl-4-host-names
[AlwaysUseRouteTable]
Determines whether to use the device's routing table to obtain the
URI host name and optionally, an IP profile (per call) even if a Proxy
server is used.
[0] Disable = (Default) Don't use internal routing table.
[1] Enable = Use the Outbound IP Routing Table.
Notes:
This parameter appears only if the 'Use Default Proxy' parameter
is enabled.
The domain name is used instead of a Proxy name or IP address
in the INVITE SIP URI.
Web/EMS: Tel to IP
Routing Mode
CLI: tel2ip-rte-mode
[RouteModeTel2IP]
For a description of this parameter, see 'Configuring Outbound IP
Routing Table' on page 327.
To Next Page
Loading...
